Your cart is empty.
Your cart is empty.CRC Cutting Oil Thread Cutting Lubricant is suitable for use with all manual and motorized threading machines, and enhances the life of your tools. It has outstanding anti-weld characteristics. This NSF P1 Registered lubricant is suited for tapping, threading, drilling, sawing, shearing, turning, and reaming metal components, pipes, conduit, screws, bolt holes, housings, aluminum sheets, strapping, gears, and chains.
Richard
Reviewed in the United States on October 4, 2024
Thus is a foam and it works great
Joe C
Reviewed in the United States on September 15, 2023
I use this spray to cut pipe threads with a small power threader from harbor freight. This spray is great when trying to thread a pipe in the wall especially vertically since it does not run like oil
DaddyMurray69
Reviewed in the United States on August 21, 2022
Must have to save your drill bits. Will adhere to drill bit better than WD40.
Sven Peterson
Reviewed in the United States on December 24, 2022
I have to field tap an awful lot of 1/4-20 and 3/8 holes and if not for CRC Cutting Oil it’d be a nearly impossible task…
Mike
Reviewed in the United States on July 5, 2021
Nice cutting fluid. Used it to drill holes in a 1/4” thick angle iron gate which was already mounted so we had to drill vertically. It did a good job as it is thicker than just regular cutting fluid.
Cameron McGroarty
Reviewed in the United States on February 3, 2021
This sticks very well for drilling or tapping typical small holes ie 1/2”. It doesn’t run off the drill bit. However, for threading rigid conduit or black pipe, it’s not fluid enough. You have to re apply constantly. Definitely recommend for tapping smaller holes.
Eric
Reviewed in the United States on July 20, 2020
I am used to the ridgid brand spray cutting oil. This one is very thick and almost foamy. I found it harder to thread pipe with.
A2theJackson
Reviewed in the United States on July 6, 2017
Really nice cutting oilI picked this up as I was planning on bolting 5/4x6x8 treated lumber to a cheap Lowes 5x8 trailer, and drilling into the L-channel steel. Combined with a Cobalt bit, this made it a breeze!! I could really tell when the bit was struggling without the oil. This helped it cut clean, smooth, and cool. The best part was that when I had to cut vertically, this stuck in place. I would spray it on, and it would stay there, holding onto the bit.Highly recommended if you need quality, viscous oil for cutting.
Recommended Products
$90.46
$ 37 .99 $37.99
$17.23
$ 6 .99 $6.99