Your cart is empty.
Your cart is empty.Control Devices, Brass, 1/4 inch proportional pressure Relief Valve with @SCFM and a pressure range of 0-20 psi
HClarkx
Reviewed in the United States on June 19, 2023
Did not work for me. When set under about 5 psi the pressure release was unpredictable.
Joshua
Reviewed in the United States on August 1, 2022
Joe Martin
Reviewed in the United States on September 17, 2021
Bought two of these to make spunding valves for pressure fermenting. Had my co2 regulator set at 10 psi neither one of these valves held any pressure, even being all the way closed. Ended up buying bowtie type spunding valves
The Gun Box
Reviewed in the United States on June 18, 2020
We use these in a pretty low pressure application (less than 3 PSI) to prevent damage in the event of a regulator failure and have been quite happy with them. The adjustability is nice, and the design seems simple and reliable. We've used about 40 of these and really haven't had any issues.
Lee Paulsen
Reviewed in the United States on December 25, 2017
100% useless. Won't hold any pressure. Leaks continuously at anything above 1 psi.
Barrett M. Dahl
Reviewed in the United States on December 21, 2017
Garbage. Even after removing the "locking" nut so I could tighten it further, it still leaked at 2-3 psi. BTW the threads on the "locking" nut are a joke and I was able to just pull it off rather than having to unscrew it.
Online shopper guy
Reviewed in the United States on November 26, 2017
Absolutely garbage. Leaks at any pressure at all. 2 psi it will already be hissing when tightened fully. Trash...
Recommended Products
