Your cart is empty.
Your cart is empty.
Specification:
5-24 V universal to control signal, without series resistance;
TTL compatible and optically isolated inputs to 5.6A;
Input voltage 20-50VDC;
Up to 128 subdivision, 16 selectable micro-step resolutions of 400-25,600 via DIP switches;
8 selectable output current settings of 1.4A to 5.6A via DIP switches;
Pulse input frequency up to 200 KHz;
Protections for over-voltage and over-current.
Electrical Specifications:
* Output Peak Current: 1.4~5.6A
* Input Voltage: +20~50VDC (Typical 24-48VDC)
* Logic Signal Current: 7~16mA (Typical 10mA)
* Pulse Input Frequency: 0~200kHz
* Isolation Resistance: 500MΩ
* Vibration: 10-55Hz/0.15mm
* Weight: Approx.260g
Keith o Brien
Reviewed in the United Kingdom on June 7, 2024
Good controller, works fine and build quality is probably a little higher than others I've used recently.
JASC
Reviewed in the United States on June 22, 2024
Excelente producto
TimeRider62
Reviewed in the United States on March 5, 2024
I don't have much to say other than these have worked flawlessly. Can't expect more than that.
Megan R.
Reviewed in the United States on August 25, 2023
I should have looked more carefull. Resolutions starts at 400 step and I need it to be 200 step.Should have goten STEPPERONLINE DM556T
Andre
Reviewed in Canada on September 20, 2022
bonne qualité
Randy
Reviewed in the United States on December 30, 2022
I bought two of these and hooked them to a NEMA34 stepper which is rated at 5.5 amps. No matter where I set the current selector DIP switches, the maximum current I can get is about 1.5 amps. My power supply has 10 Amp capacity and is running at 30 Volts DC. I originally thought the unit was not working. After further testing, I believe it IS working, but the current through the motor coil must be different than the current draw from the power supply. When I get an oscilloscope, I will measure voltage across the motor leads to determine the true motor current to see if it matches the specifications. I'm keeping these for now, as they seem to be functioning. Would be really nice to have an instruction manual shipped with the unit.
Steve Masuch
Reviewed in the United States on April 6, 2022
Used to add auto focus to 100w CO2 laser engraver.
P Webber
Reviewed in the United States on December 4, 2021
So far so good. 4 drivers running at 4.9 amps and couldn't be happier
Ruby Davis
Reviewed in the United States on November 9, 2021
Worked great for my CNC
Grady
Reviewed in the United States on October 11, 2021
I am using this to control a 4th axis on my CNC mill and I am very happy with its performance. It runs amazingly cool even though I am using it over 3 AMPs on my NEMA 23 stepper motor 57mm 3A 2-phase 4 wire. I recommend ++. I am using a 24 Volt power supply. Great Value.
Recommended Products
