Your cart is empty.
Your cart is empty.Product Description
Specification:
- Display : LCD
- Biggest Display Value : 1999 (3 1/2)
- Sampling Rate : 3 times per secondD
- Overrange Display : "1"at the higgest digit
- Measuring Method : Double integral A/D conversionI
- nstruction for Low Voltage of Battery : showing "- + "
- Auto Power off and Data Hold function
- Working temperature: 0℃ to 40℃ , Storage temperature: -10℃ to 50℃
- Power: a 9V laminated battery(6F22)E
- nvironment temperature: 23℃±5℃,Relativehumidity: <75%
- Capacitance (C): 200pF-2000uF, accuracy up to: ± 2.5%;
- Inductance (L): 200uH-20H, up to accuracy: ± 2.5%;
- Resistance (R): 200Ω-20MΩ, accuracy up to: ±0.8%.
- Accuracy:±(%reading+digits)
- Wiring length:1.5M
Inductance:
- Range:200uH;Resolution:0.1uH
- Range:2mH;Resolution:1uH
- Range:20mH;Resolution:10uH
- Range:200mH;Resolution:100uH
- Range:2H;Resolution:1mH
- Range:20H;Resolution:10mH
- μH=10-6H ;mH=10-3H
Moi
Reviewed in France on September 3, 2024
Bel écran LCD, livré avec une pile et un étui ,Bonne précision des mesures.Je recommande ! 👍👍👍
FRANCK TLALKA
Reviewed in France on August 11, 2024
Mesure toute inductance
Paul B.
Reviewed in the United States on June 10, 2024
Can measure very low resistance value and capacitance. Will also measure inductance.
Lalithj
Reviewed in the United States on May 6, 2024
Accurate readings and easy to use.
H. Beavers
Reviewed in the United States on March 27, 2024
Good quality device. Useful for coil and capacitor measurements.
Amable
Reviewed in Spain on February 24, 2024
Es lo que esperaba
Cliente
Reviewed in Spain on February 13, 2024
Bastantes escalas de medida.No mide resistencia en serie equivalente (ESR).
Andrew L. Dominguez
Reviewed in the United States on December 17, 2024
Unit stopped working after less than 5 months. It is only used for OHM/Resistance measurements on non-energized components (Guitar components: Potentiometers and Guitar Pickups). No reason for this unit to have quit working in such a short period of time other than it being a low-quality instrument. I HIGHLY RECOMMEND THAT NO ONE BUYS THIS OR ANYTHING FROM CAMWAY. HORRIBLE, HORRIBLE PRODUCT AND CUSTOMER SERVICE FORM AMAZON
Charger Andy
Reviewed in the United States on November 22, 2024
As other reviews say, the leads are really short. But the length of the leads factor into your readings. So it takes a little bit of getting used to but you can make it work with longer leads.
Eheleute Ackermann
Reviewed in Germany on November 22, 2024
Günstiger Preis. Für Hobbyzwecke ausreichende Genauigkeit. Alles ok.
Happy Camper
Reviewed in the United States on April 14, 2024
This meter seems accurate enough, at least for hobby purposes. The leads are too short to reach both ends of a large inductor. I’ll look for some longer leads.
Flyin'Hawaiian
Reviewed in the United States on December 20, 2022
Most of my usage is for 1w radial inductors on older amateur radio equipment, and mainly looking for dead pieces, so they're either close to rating on components or completely open circuits. Also tested a few electrolytic caps and all were very close to printed capacitance (ie. 47uf was 46.4uf).Funny thing, the zeroing knob did nothing at all in L and C modes (and I didn't have a resistor handy to test), regardless of shorting leads or with a component hooked up.Overall, very good unit for the price, but if you need absolutely accurate readings, plan on purchasing a professional LCR tester and prepare to spend 400+ bucks for one that's gonna get you to 1% accuracy.
VirtualUser
Reviewed in the United States on July 15, 2021
Inexpensive. Works. Accurate.After testing with known parts, I measured unmarked small inductors and chip capacitors on a commercial PCB. Before I got this, I had used a signal generator and a known capacitor to estimate an inductor by the resonant frequency. This LCR meter worked in-circuit and matched my estimate within a few percent, but with far less effort. I should have purchased this long ago.
Recommended Products