Your cart is empty.
Your cart is empty.Product Description
Shoppaholic
Reviewed in the United States on December 6, 2024
Awesome set of burrs priced cheaper than others. I will definitely buy from this seller again.
Misa lyons
Reviewed in the United States on December 5, 2024
Came quick and works great.
Mark R
Reviewed in the United States on December 24, 2024
These rotary burr tools fitted my Dremel tool well. So far I have used them to cut wiring slots in some shelves. I also tried them on some pine wood and they cut through like butter without clogging. They do better with the Dremel set for high speed.They are going to be useful whenever I need to remove wood or plastic for one of my projects.
LB
Reviewed in the United States on December 23, 2024
I just got into wood carving and these came at the perfect time. They fit perfectly on my Dremel with the 1/8" collet. They struggled at 10000 RPM, but rev it up to 20k and they cut like butter. Just what I need for carving out cups and wells in places I can't rout. I can also engrave with them, especially the pointy flame burr. Also great for grinding off welding seams, casting burrs and general unwanted bits on my DIY plastic projects. The finish IS very coarse, as described, so you need to follow up with sanding attachments. Excited to collect more burr shapes from this brand!
Customer
Reviewed in the United States on December 16, 2024
I've just started getting into wood carving with my Dremel Drill. I saw rotary burr bits like these recommended in a few videos I watched. These Caelum drill bits seem well made and they worked just like I expected them to. For me around 20,000 RPM was a good speed. I've still got a lot to learn but I'm excited to have these in my tool box. I have a couple of similar rotary burr bits from Kutzall that cost twice as much as these did. I can't really tell a difference between the two brands so far. It seems like these Caelum bits are a pretty good value compared to other products out there.
Better Deals
Reviewed in the United States on December 16, 2024
These burrs work well. They're sharp and remove material cleanly. The shaft is exactly 0.1230 inches (1/8th) on both of them. So far, I've only used them on oak. The ball-shaped one does a good job of digging out corners and creating a sort-of reverse round over. Also note that the shaft length on this one is shorter, just under an inch. The flame-shaped one is more universal, it can do a bit of everything. Having a tool with adjustable speed, especially on the high end, makes a huge difference in how this bit performs. On my red tool, somewhere around 80% of maximum seems to be the sweet spot for most of the stuff I've done in oak.
Joe
Reviewed in the United States on November 5, 2024
I use these to take off the bulk of my support pocs on PLA prints, great time saver.
RICHARD K LENEAVE
Reviewed in the United States on November 18, 2024
Great value and less expensive than some other brands. The 1/8 inch shaft fits perfectly in my chuck. Cuts through wood like hot butter, makes carving easier. I have run this bit through wood at full throttle and it has not broken or dulled. Absolutely worth grabbing. Couldn’t be happier.
Recommended Products