Shopping Cart

Your cart is empty.

Your cart is empty.

Bosch 85285 1/4 in. x 1/4 in. Carbide 1-Flute Flush Trim Bit

4.6 (10) Write Review
Free shipping on orders over $29.99

$15.29

$ 6 .99 $6.99

In Stock

1.Size:1 Count (pack Of 1)


About this item

  • For trimming high-pressure laminates flush to a substrate
  • Solid pilot wipes clean - no ball bearing seizure from adhesives
  • Classic design for high production countertop and fixture production
  • Solid Carbide for long life in production applications


Premium-quality micrograin solid carbide bit is precision ground for an Extra-Fine finish With maximum sharpness and edge retention. Flush trim bits are used for laminate work or for template and pattern work. For template application, the bearing follows the template, while the cutting edges trim The work piece.Single flute trim Bit allows for a faster feed rate. Solid carbide gives Best rigidity and long life.


David
Reviewed in the United States on March 4, 2025
Maybe it’s just me, but it broke almost immediately. There is no cutting edge on the top so when hit a small obstacle with the tip it was done.
Terry B.
Reviewed in Canada on January 19, 2025
worked nicely, it did put a faint line in the side but lets face it I bought it knowing it didnt have a bearing so I wont hold that against it. It was a good price and I only needed to do a couple cuts.
Melissa
Reviewed in the United States on September 3, 2024
Great bit, good value for the price. Did exactly what I needed it to for trimming laminate sheets.
Jose soto
Reviewed in the United States on June 19, 2024
Entrega rápida
Timothy
Reviewed in the United States on January 19, 2024
This laminate flush trim bit was sharp and worked well. However, it let scratches in the laminate sides where the bit rides.
Norm L
Reviewed in Canada on April 29, 2024
Bought this to trim veneer on my speaker build for the speaker cutout. workfind for the woofer but the tweeter depth as not deep enough for this bit to work.
DAVID J GRIMMER
Reviewed in the United States on July 7, 2023
I use this bit to cut the tabs left by a CNC router. I use it in a small trim router and it does a great job cutting through the thin tabs holding my product to the board it was made from.
Kim
Reviewed in the United States on May 21, 2023
Would buy again.
Luis Ibarrondo
Reviewed in the United States on December 30, 2022
I would recommend this tool if your cutting laminate
Dave H
Reviewed in the United States on December 29, 2019
Not much to say, but this worked great as advertised. Used a small amount of household oil on my fingertip and made sure it was lubricated good, then went at a normal pace. Do not hold against the edge without moving or it will burn. Clean up the oil with some solvent and hit the edge with a file to smooth it down a little.