Your cart is empty.
Your cart is empty.NEW Top Quality BMI Heavy Gauge 6 foot long cord; Replacement Power Cord for up to 1000w Dodge Cummins Diesel Block Heaters. Fits Following Engines in Any Dodge Chassis: 1989-2007 Dodge Cummins 5.9L Diesel Engines 2007-2024+ Dodge Cummins 6.7L Diesel Engines New heavy gauge 6 foot long power cord for 120V AC Made with a high quality flexible rubber sheathing (not a cheap plastic covering that cracks in the cold) Plug ends are molded into cord, not just glued on to it like products of lesser quality. Keeps moisture out. Watch out for the cheap cords with the "hex" nuts on the end.
Krystal
Reviewed in the United States on April 14, 2024
Sorry, no pics. But it works. My poor old truck dodge Ram 2007 was having a hard time starting up last winter and my husband figured it already had a hook up, we just needed this to plug it in to keep the engine warm and in the mornings, we didn’t have to struggle at all to get it started up and running. So we’re so glad we got this. Wished we could’ve gotten this a long time ago ha.
james a.
Reviewed in the United States on November 29, 2023
Hopefully this helps someone I have a 2007 5.9 Cummings and this fit Mt truck perfectly and works just as good as the more expensive one's.
Thomas G
Reviewed in the United States on December 29, 2022
If your Ram didn't come with a block heater, chances are it just doesn't have the cord. My 2012 Ram 3500 didn't have the cord. After a few YouTube searches, Ram usually puts the block heater in, but doesn't install the cord unless you Op for it when you purchase. Look right behind your oil filter and if you see a rubber cap then you have the heater element installed and not the cord. Buy this, pull the rubber cap off, screw on the cord and route it to the front bumper. If you want to make sure it will work, Ohm it out to make sure.
Dean Warren
Reviewed in the United States on December 26, 2022
It asks to rate install, I gave it 5, without removing the oil filter it's a -5, not the cords fault, Rams. Once I did that easy and it works just fine. Well worth the $$$
Recon4_u
Reviewed in the United States on December 16, 2022
Great product. Hooked right up to the factory block heater connection. Had to remove the intake to install but routing to the front was easy. Great product and cost 3/4 what mopar wanted.
charles
Reviewed in the United States on February 9, 2020
installed on 2007 ram 2500 with 5.9 cummings diesel. the hardest part was removing cap where plugin goes, also had to loosen air filter box tubing to get in there with hands to get it started then used a long flat tip screwdriver with hammer to tighten it up, it has little groves in cap just tapped it until it was tightened. it took about an hour. I plug it in at night with a timer plug so it comes on at midnight and shuts off at 6 in the morning, I start trk at 5.15 and leave at 5.30 and have heat coming out of heater. im happy and so is trk.
R. Lewis
Reviewed in the United States on May 6, 2018
Fit my Truck and only took a couple of minutes to install. I unplugged the old one and plugged this one in and reattached to the harness and done. Works perfect. About as easy as unplugging one electrical chord in the house and plugging in another one... But it's outside and its winter. Lol!
norma
Reviewed in the United States on February 15, 2018
Fairly easy to install. A little trouble with routing because oil filter is in front of it. Been using it for a couple of months now and works great.
Recommended Products
