Your cart is empty.
Your cart is empty.Product Description
Adapters
1. 1/4" SAE brass fittings for standard Schrader valve.
2. Brass fittings for small Schrader valve on part Ford.
3. Brass fittings for M6 fuel pressure test port.
Clear data
The fuel pressure gauge with a dual color-coded scale makes the data more intuitive and clear.
Updated
Unlike regular products on the market, the aluminum fitting in the kit needs to be connected to the gauge by the hose.
BETOOLL Fuel pressure gauge kit fits most vehicles with a gasoline/gas engine fuel injection system. (Does not compatible with Bosch, CIS Jetronic, TB System on GM vehicles.)
Robbie B. Ballance
Reviewed in the United States on February 20, 2025
It's cheap could stand to be better quality
F. Herremans
Reviewed in the United States on February 15, 2025
Every thing you need to check fuel pressure on a Kawasaki kvf750 is in this kit. You will need to buy the clamps for fuel injector hose.
Gene M. Ledoux
Reviewed in the United States on August 9, 2024
Worked great well packaged adequate adapters to get the job done.
Brant Shalek
Reviewed in the United States on June 12, 2024
Very nice for my purpose, which was diagnosing the fuel pump assembly on my dirt bike. Bought a few extra clamps and a few extra feet of fuel hose so I could measure my fuel pump pressure while fuel pump was on (fuel pump pressure *has* to be measured while the vehicle/bike is running with an open flow to the system - don't have your fuel pump dead end into the fuel gauge because it'll give you a higher reading than if you're running your car/motorcycle). Was able to quickly rule out my fuel pump assembly and found out my TSP sensor was bad. Pair this with a OBD2 engine fault reader for car/motorcycle diagnostics.
JBuz
Reviewed in the United States on May 1, 2024
I used this exact kit at the shop I worked at for over 4 years without a single issue. I like it so much I bought one for my own tool collection as well. Great product for the money
megan
Reviewed in the United States on December 29, 2024
early FI mustang motor
Rick Thomas
Reviewed in the United States on December 21, 2024
Item works well. No leakage if used properly.
Sparky
Reviewed in the United States on October 31, 2023
I bought this unit to test the fuel pressure at my fuel rail on a BMW. It took me almost 2 months between purchase and use. The pressure gauge does not work. I get 0 PSI at the rail on a running engine. Fuel sprayed everywhere a few times at the fittings until I used plumbers tape at each point and cranked down on the fittings with water pump pliers. Still shows 0 PSI with the key on, and also on a running engine. I concluded the gauge is faulty. I went to the "product support" webpage and it is not a functioning website, its says "under construction." So, my advice is to avoid this product.
Recommended Products