Your cart is empty.
Your cart is empty.Product Description
Stainless steel thread rod provides corrosion resistance and offers thermal and electrical conductivity.
Beduan 304 Stainless Steel Fully Threaded Screw Rod
Right Hand Threads Used for Bolts Clamps Hangers U-Bolts
Threaded rods and studs are fasteners that screw into threaded nuts or tapped holes, allowing for assembly of components. They have threads along part or all of their length. Those that are partially threaded have equal or unequal thread lengths on one or both ends. Studs are also available with a perforated base, weld projections, or a press-in captive head for securing to the surface of a component.
Toddd L. Tomlinson
Reviewed in the United States on August 11, 2024
I replaced the old bolts holding the air cleaner box on my Honda mower with these and no longer have to struggle to replace the carb after cleaning.
rodder98
Reviewed in the United States on July 14, 2024
I like the nice quality of the rod. I used it to replace two Honda mower bolts that fasten the carburetor and several other items to the engine, (by installing 2 studs where the 2 bolts were located). This is the way Honda should have built them.
Terry J Mahlberg
Reviewed in the United States on July 13, 2024
The bolt were good but I ordered them way to long, my mistake.
Jeter Creek
Reviewed in the United States on June 14, 2024
Yep. Cut them to length and screwed on the nuts. Replacing carb bolts in theHonda lawn mower. Quality parts.
Steve R.
Reviewed in the United States on December 16, 2024
Fit perfectly and performed perfectly.
Joseph W Hall
Reviewed in the United States on October 31, 2024
Great Value
Yusuf
Reviewed in the United States on January 8, 2024
The threaded rod is well made. Nuts thread the whole way through without catching, no burrs or defects of any kind. I needed to cut one down and round off the end, and I had no issues with that. Rod is made of T304, just like advertised, and I've had no corrosion.
J S
Reviewed in the United States on November 10, 2023
I purchased two of these to help with the absurd gasket-stacking layout Honda chose for their GCV160-powered mowers. I cut the rod in half and re-finished the edges so I could thread both rods into my GCV160 engine block, then start the painstaking process of gasket, part, gasket, part, gasket part to make the 6-gasket "hamburger" Honda expects before pulling one side and installing the OEM bolts in their place. Well, needless to say, buying this threaded rod is a heck of a lot cheaper than some of the kits online to help you with the same process. I know they'll last after leaving them outside accidentally for a couple of weeks, not a sign of rust. Not bad for the humidity of summer. Very happy with my purchase.
Recommended Products