Your cart is empty.
Your cart is empty.NOTE: Please carefully check your vehicle type with our fitment, and please compare our part pictures with your old part to avoid the wrong purchase.
Panda
Reviewed in the United States on March 5, 2025
Fit perfect.
Mrmalx
Reviewed in the United States on February 8, 2025
It worked but didn’t come with hardware. Also had to shorten the rod.
Mfam
Reviewed in the United States on February 22, 2025
Like Factory! Removed the baling twine this works perfect. Easy DIY. Nice painted metal. J hook probably would fit a variety of batteries in case you have a nonYODA batt.
Bryce J Anderson
Reviewed in the United States on January 21, 2025
Toyota uses this bracket in a lot of their vehicle so I took the chance buying this bracket for my GCC spec 1999 Toyota Landcruiser. The bracket works to hold the battery in place and is easy to install, however the fitment is just slightly off so the battery is pushed back a little past where it is supposed to be sitting. However, the cost of this product is much cheaper than buying all of the individual parts from a Toyota dealer or parts distributor. Definitely recommend this product if you need to replace the bracket in an LC100.
Chad richards
Reviewed in the United States on January 20, 2025
This is great replacement and fixed my issue of a missing battery Hold down on my 91 Toyota pickup. I was tired of using bungee cords and found this. I would buy again!
Ranger
Reviewed in the United States on September 26, 2024
This battery holding bracket feels like it's made of quality steel, and the hardware included is great. But it's not quite long enough on a 1996 4runner. It pushes the battery up against the coolant overflow reservoir, and the j-bolt ends up at an angle, as seen in the photos. It'll work to secure the battery, but an original Toyota part would fit more correctly. Not bad for $20, but not great either.
jeremy morris
Reviewed in the United States on March 1, 2024
Used as a replacement for a 1987 Toyota 4runner.Fit perfectly! Seems great in quality. No burs or sharp edges. No scratches. Has done it's job over 2000 miles over many rough wood roads and highways. Highly recommend.
jason
Reviewed in the United States on November 22, 2024
Perfect fit 1997 Toyota T100 6 cylinder.COMES WITH 10mm BOLT FOR FRAME AND NUT/METAL ARM FOR OTHER SIDE
Recommended Products
