Your cart is empty.
Your cart is empty.3.6 out of 5 stars
- #305,636 in Electronics (See Top 100 in Electronics)
- #185 in Quadcopter Camera Mounts
Product Description
Wasted my money
Reviewed in the United States on August 28, 2024
These guards were very easy to install on my drone (Avata 2). I haven’t run my drone into anything, yet, so it’s hard to say how well they actually protect. They so seem pretty sturdy and won’t snap when you do have a head on collision.
Mr. T
Reviewed in the United States on August 28, 2024
I had ordered this set for my Avata 2 by DJI. I have a set of red bumpers from another maker and replaced them with these black ones. They did fit with some minor adjustments. Basically, I had to screw in the top screw first and then rotate the arm down and actually stretch it slightly to align with the second hole. It comes with the longer replacement screws and a small screwdriver to assist you with the job. The slight difference that was causing the tension in the arm and the slight misalignment was enough for me to install it and then take it off afterwards. I have included a picture of what it did look like with the black bumpers installed, before my switching it back to the red set. I hope that this helps.
mike
Reviewed in the United States on August 22, 2024
These show up in the footage when in wide angle mode, but still good to have the extra protection.
Texian
Reviewed in the United States on August 2, 2024
This is a good set of guards that have a nice finish/color. The weight is nominal and the overall look and feel are attractive. The only downside that I found with the product is that the screws are easily stripped. The screwdriver fit nicely during the install precess however about the time that the friction began to ramp up, the head was easily gummed up a bit. I did not finish the install and I removed the screw right away. No need to do any more damage and risk having to do a LOT of work to remove them. That is sad because the guard themselves were pretty nice.
Joeyzoom
Reviewed in the United States on July 5, 2024
These bumpers fit the quadcopter very well. The bumpers are sturdy and readily impact resistant, and add a tougher look to the drone. This kit comes with the screws and driver necessary for install, which is very easy to DIY. I don't plan on running into anything with my drone, but having sturdy bumpers adds protection for the camera and gimbal, the most sensitive pieces of the drone.
Recommended Products