Your cart is empty.
Your cart is empty.This switch is found on 208-230vac motors but can be used on 110v also It has 3 screw terminals on the back/ bottom of the Micro switch where wires are connected (wires typically only connected to 2 out the 3 terminals). The terminals are usually marked "NO" "NC" "COMMON" or "COM" and the switch can be set up for normally open or normally closed operation.The front of the switch has a metal button/ plunger which is what actuates the switches operation. The plunger goes into a brass colored housing which has threads and nuts allowing the switch to be mounted to the face plate/ cover of the motor. This switch can also be waterproofed by adding a protective rubber cover over the plunger area of the switch if your lift is outside. Call for details on cover. These switches are high quality units meeting all electrical codes and requirements. All our switches have been 10,000 press tested to ensure long life. This switch will get you back up and running and put your lift back to work for you!
Eric
Reviewed in the United States on September 3, 2019
It took 2 minutes to install and the switch works perfectly.
Dave
Reviewed in the United States on May 30, 2019
works good, wish it came with a weatherproof boot.
Mark parrr
Reviewed in the United States on May 21, 2019
Was just what we needed to fix the lift..I could not find one locally
Sandy Smith
Reviewed in the United States on November 8, 2019
came apart cheap plastic tabs push wire back in box and it came apart
SJ
Reviewed in the United States on October 8, 2019
switch sticks
tony habib
Reviewed in the United States on March 29, 2018
worked well
Philip Begley
Reviewed in the United States on January 23, 2018
Original product at great price
joseph breslawski
Reviewed in the United States on November 6, 2017
Perfect fit. Couldn't find in local electrical supply house.
Recommended Products
$8.99
$ 3 .99 $3.99