Your cart is empty.
Your cart is empty.David
Reviewed in the United States on June 22, 2023
No matter what way you route this the leads are too short and put too much strain and tension on the crimps. I had to extended and pretty much remake the whole harness.
KINGxCRABB
Reviewed in the United States on September 11, 2022
Yousif buali
Reviewed in the United States on August 1, 2021
Good quality
Sami Lahti
Reviewed in the United States on March 11, 2021
allgood
Stein
Reviewed in the United States on December 13, 2021
Great product got my project car up and running I had to undo the wire loom so I could get it to to each coil but I do have an ict coil holder on so it may be due to that
Brendan
Reviewed in the United States on January 29, 2020
These are made with china knock off connectors, NOT Delphi quality.Splices for ground/power/low reference are just crimped and taped over with layer of electrical tape, I could see this being an issue after some time in service. I will remove terminal from white plug and slide some heavy wall heat shrink over the splice, and these should work fine.The cable seal on the large white plug does not seal the cavity, it is loose inside. The end at the coils does not even have the cable seals! nothing!
Rolando velez casanova
Reviewed in the United States on January 14, 2020
Good product and easy to install
Jim Babbs
Reviewed in the United States on April 23, 2018
fits good ,good quality
Recommended Products