Your cart is empty.
Your cart is empty.The Astro Pneumatic 200-283 is a 3 Slot 1/4-1/8" Collet Reducer. This item is built to be used with the T210 1/4" Medium Die Grinder with Safety Lever.
Art
Reviewed in the United States on August 8, 2024
Works great
BrewCityRider
Reviewed in the United States on February 1, 2024
The media could not be loaded.
nathan
Reviewed in the United States on January 24, 2024
But given its small size it is extremely easy to lose. Be careful!
James Knobloch
Reviewed in the United States on September 23, 2023
Item works for what it was intended for. No apparent design flaws and weaknesses observed.
Josh C.
Reviewed in the United States on May 16, 2023
It fit my die grinder the way it should and held the 1/8” bits I was using tightly.
Cliente de
Reviewed in Mexico on February 29, 2020
Duro 1 semana, y perdió el agarre, termina abriéndose y dejando de sujetar, aparte nisiquiera es el de la publicacion
Sébastien Plante
Reviewed in Canada on August 14, 2019
It's working fine, but it seems I have to tight a little more so the bit dosent slip and then, after the job, it's kinda "stuck" in... not sure if the others are working better than this.Make sure you align the notch with the notch on the other collet.
JWYork
Reviewed in the United Kingdom on June 26, 2019
Makes wood carving more ffordable
Don Reichert
Reviewed in Canada on June 27, 2018
This one worked great for me, however the one I got only had 2 slots, not 3. It held very well, in fact it was quite tight even putting it into the router, without even tightening. I have bought a couple others for $.99 from other online places, end up being metric and does not hold.
Marshall David WahlstromHelgren
Reviewed in the United States on October 21, 2018
So the inside of my bike fork where the quill is inserted and down past the headset was rusty I needed this to hold a Dremel ¾ rod brass wire brush on an extension bar for drill bits. This collet reducer did exactly what I needed it to do, and while the cleaning an rust removal it wasn’t easy but it got done, now my fork on the inside is really clean, hopefully I will avoid rust in the future. I highly recommended this!
Poppa
Reviewed in Canada on January 25, 2017
It lets me use 1/8 in. dremel tool bits in the router on the CNC machine. Works good so far.
Donald R. Giles
Reviewed in the United States on December 20, 2016
Collet adapter works well but is not easy to remove from 1/8" bits after use. Really tight.
Awesome Wood Things
Reviewed in the United States on November 12, 2015
This was suggested for the DeWalt 611 trim router. It didn't work for me! The bottom of this unit is solid and will not compress. That must be a huge design flaw. The bit fell out several times. I finally tightened the collet of the router so hard, using all my strength, it finally kind-of worked, sort-of.Other brands make these reducers with only one slit running the entire length of the unit, top to bottom, and that allow for pressure to be applied anywhere. Again, the solid bottom area of this unit WILL NOT COMPRESS like it should. This product is flawed by design. Do not buy!
Recommended Products
