Your cart is empty.
Your cart is empty.Only the finest raw materials and state-of-art technologies are used to produce these vital mounting and cosmetic Solutions that render a vehicle dashboard into an attractive showplace of pride and profits for your business. For something so vital, trust nothing less than American International installer preferred custom mounting Kits. They pioneered the car stereo installation business, and over 60 years of experience continues to TEACH them that their innovation today, drives your business and their industry forward into the future. Installers and business professionals continue to rely upon the innovative and quality products that can only be achieved from within their Camarillo, California facilities where American International Kits are produced to a precise quality standard that surpasses the OEM. Ai only use the finest raw materials and state-of-the-art technologies to create mounting and cosmetic Solutions that render a vehicle dashboard into an attractive showplace of pride for your craft, and the Primary profit center for your business.
Drew
Reviewed in the United States on August 1, 2024
Didn’t work for my application the speakers didn’t mount right
Domingo claudio
Reviewed in the United States on January 29, 2024
If you have G body and need to install some 6 × 9 these adapters will work perfecthe .
Kevin Howard
Reviewed in the United States on May 25, 2022
These worked perfect for adding 6x9 speakers to my 1984 Cutlass supreme
Reginald Wordlaw
Reviewed in the United States on March 16, 2022
So far holding up my 6x9s which has huge magnets.
Eric
Reviewed in Australia on May 14, 2020
I have a 81 Cutlass supreme and it fit perfectly.Would have liked to have seen some screws, clips and also some tape foam to lay around the edge of the adapter to stop rattling.Other than that solid product.
Patrick Rubio
Reviewed in the United States on January 15, 2018
Fit is perfect. No issues with the install. One thing I would mention that is not immediately obvious, the wire hangars are side specific. After test fitting you'll see which one goes on what side. I would highly recommend them and would buy again if needed.
Dennis Ryan 2.0
Reviewed in the United States on April 23, 2018
I got these to swap out the 4x10s in the rear of my 87 Regal and they got the job done fairly well. I did find a tip that indicated the hangers are side specific and you need to install them with the longer arm towards the rear of the vehicle. The drivers side secured the speaker very well but the pass side isn’t as tight of a fit. It has a little more room for movement than I prefer on the pass side speaker but I didn’t notice any impact on sound quality with weird vibrations or resonance during a 20 min drive.It would have been nice if the adapters came with hardware to mount the speakers to them but nothing a quick trip to the hardware store couldn’t solve. I think it probably took me longer to get the adapters mounted to the speakers then installing them in the car.Finally loving the sound of my stereo in my old cruiser.
pyrateman48
Reviewed in the United States on July 18, 2016
Didn't quite fit right for my truck but is made of sturdy materials.
KLM
Reviewed in the United States on December 30, 2013
I replaced the original 4x10 speakers in my 87 Regal Grand National. These adapters worked well with the 3 way 6x9 pioneer speakers I installed. I had to purchase some nuts and bolts to secure the speakers to the adapters. The provided clips held the speakers in place and all is good.
Recommended Products
$28.99
$ 14 .99 $14.99