Your cart is empty.
Your cart is empty.Product Description
CHECKING SIZE WARNING!!! Aluminum Router Mounting Plate
The size of the router board is 234mm x 120mm x 8mm. Please check our board size to make sure it matches your router. The detailed size is on the second picture. The unit of measurement is millimeters.
- Plate material: Aluminum alloy
- Insert material: ABS plastic
- Color: Silver
- Size: About 235 X 120 X 8mm/9.3 x 4.7 x 0.3inch
- Weight: 1.2lb
PERFECT FOR SMALL TRIMMER ROUTER
This aluminum router mounting plate is suitable for most small trimming routers, please pay attention to the size before buying. For a very small number of woodworking routers with special hole spacing, you need to drill holes from the slot reserved on the back for installation. If you have any questions, please come to consult.
WOOD WORKER HELPER
Our router table insert plate has many holes to fit different brands of routes. It comes with four different red covers to fit different bits sizes. There are measures on the face of the plate in inches and centimeters on both sides with the bit positioned on 0. Also, the face contains 45 degree angle marks and an opening to adjust router height.
STURDY ALUMINUM MATERIAL:
This router table insert plate is made of aluminum alloy, which is durable sturdy and anti-rust. Router table mounting plate is integrally die-casted, flat and smooth.
- 1 X Aluminum Router Table Insert Plate
- 4 X red insert rings
- 1 X screws pack
Bill
Reviewed in the United States on December 9, 2024
The product looks sturdy, but the labeling is definitely misleading as it does not fit at a Walt trim router or a cheap craftsman trim router. I’m going to have to bring it to the store with me and pick up another cheap trim router to see what it actually fits. This intended purpose for me at least was to build a small router table and that will handle my little trim, router and this aluminum insert would’ve been perfect for it however, it might not be cost-effective if I have to actually go out and purchase another router to make it fit besides the two that I already have and I use exclusively small trim routers
Captain Obvious
Reviewed in the United States on May 16, 2022
Inserts are a little small and catches on product
Zack M
Reviewed in the United States on December 30, 2022
Scrub-sanded some scrap wood to reveal a funky pattern, epoxy-coated the surface, and installed this inexpensive router plate. Fits my cheap trim router/base perfectly (basically the same Makita clone that’s sold all over Amazon). The included hardware made this a simple project, and it’s working great!Tip: When routing out the area for the plate itself, don’t be afraid to go a little deeper if needed. Then use a few washers on the 4 screws to perfectly level the plate into the table itself.
Recommended Products
$343.88
$ 99 .00 $99.00