Your cart is empty.
Your cart is empty. Product Introduction:
This module is mainly placed behind the stepper motor to obtain the rotation angle of the stepper motor. This principle is to use the AS5600 magnetic encoding, and then stick a magnet on the main shaft of the stepping motor. Information such as the rotation speed of the spindle can be obtained through magnetic encoding.
Product Parameter:
Product name: AS5600 magnetic encoder
Product size: 23mm*23mm
Product Type: Non contact magnetic induction
Output mode: IIC, PWM, voltage, etc.
PS: Manual measurement, if there is any error, please understand!
Interface Description:
DIR: Rotation direction
SCL: IC communication . Interface Description
DIR: Rotation direction
SCL: IC communication clock line
SDA: IC communication data line
VCC:3.3V
OUT: PWN/analog voltage output
GND: power ground
PGO: mode selection (internal pull-up, ground = programming mode B)
(Ground = clockwise value increases; connected toVCC = clockwise value decreases)
Features:
It is made of KB-A grade FR 4 glass fiber board with a thickness of 1.6mm. The board surface is flat and not easy to be bent. Each PCB board has been tested by flying probes before leaving the factory, and the quality is worth relying on.
Non-contact magnetic induction angle measurement module. High precision, multiple output modes, IC, PWM, voltage, etc.
AS5600 is also equipped with an intelligent low power consumption mode, which automatically reduces power consumption. The input pin (DIR) selects the output polarity rotation direction.
Customer
Reviewed in the United States on June 17, 2023
I've made several purchases of these boards (from other vendors also) and had a problem with every one. If you just want to use these as a full scale 0 - 360 analog out then it will probably work fine - after you remove R4. However, if you want to change the output by programming the internal registers you will find that these chips have already been programmed or are defective. The registers on each chip can be programmed 3 times, and only once for the zero and span settings. Every board I looked at already had it's zero and span programmed to either 0-360, or 0-90 and displayed that only 2 more burns were left. I had to get replacement AS5600s from Digikey for them to work correctly. One other thing - if you want to use this board at 5V you need to remove R1. R1 is a zero Ohm resistor that connects the 5V and 3.3V pins on the chip. It is required of you are running at 3.3V but needs to be removed for 5V.
R. Done
Reviewed in the United States on April 6, 2023
I was about to return these, but I found a review for a similar product by another vendor that you have to remove R4 to get analog output. Doing that got me reasonable values. Dont know how accurate they are yet, but at least they seem to work. Thanks P. Meyer!
Recommended Products
$38.00
$ 19 .99 $19.99