Your cart is empty.
Your cart is empty.Position the thicker side toward the end to lower the dot. Position the thicker side toward the front to raise the dot.
Joseph Eatherly
Reviewed in the United States on September 9, 2024
Worked perfectly and adds almost no total height to red dor.
Customer
Reviewed in the United States on March 23, 2024
I needed adjustment for the optic sight on a pistol. I ran out of elevation, so I bought this shim from Ade Optical on Amazon. It arrived quickly, and worked perfectly, putting the optic right where it needed to be.
Customer
Reviewed in the United States on December 5, 2024
Worked just like I hoped it would and gave me enuf elevation to sight in my dot
shaner
Reviewed in the United States on December 17, 2024
Item as described. I'm well pleased
Larry R.
Reviewed in the United States on January 13, 2024
The product works as advertised. Gave me enough up and down elevation to adjust the red dot on target.
TOCM
Reviewed in the United States on September 12, 2023
Sounds like it works for most people. Unfortunately it didn't fit my slide cut and rmr plate. Trimmed it up a bit, and it added elevation for my 507c. I wish I had ordered 2 to add more, but I'll just deal with the slightly off zero situation.
George W. Plesa
Reviewed in the United States on April 8, 2023
Grossly overpriced but it does work. I was unable to get more elevation out of my Holosun 507C mounted on a Glock 23. I put this under the sight with the thicker end to the rear and now I have elevation to spare.
readsalot
Reviewed in the United States on May 3, 2022
Although the listing indicated this is primary used to shim the sight with the thicker part of the shim under the rear of the sight (to lower the dot further), I needed to do the opposite. My gun was shooting too high and I need to shim the front to raise the dot. The shim design does allow placing the thicker end under either the front or rear part of the sight. It worked well for me and allowed me to zero my sight.
Recommended Products