Your cart is empty.
Your cart is empty.IR Emitter Shield Cover
rcvjmv
Reviewed in the United States on April 3, 2023
A bit high priced but did as intended.
MidWest
Reviewed in the United States on January 7, 2018
Pros:Light weightGood AdhesiveFits most of my IR emittersInexpensiveCons:These are VERY stiff and do not conform well to a surface with any curvature.Inflexible for variously shaped IR emitters
Delock
Reviewed in the United States on March 31, 2016
awesome
frankySez
Reviewed in the United States on April 18, 2016
Does what it's supposed to do: block the signal from other IR transmitters while holding an emitter directly on the receiver. One note, the ones I got were actually rectangular - unlike the product image - but that wasn't a big deal for me.
Kenneth Morris
Reviewed in the United States on May 21, 2015
Works ok but can be hard to get to stick on.
Immer
Reviewed in the United States on February 13, 2015
Not Round!Depending on the layout of the device you are trying to work with. Even with this installed, the IR could still reach the eye.Flashlight will help you find the EXACT placement needed.
Clay G.
Reviewed in the United States on April 11, 2014
These don't work well at all, they are hard and if your IR emitter is slightly large or different shaped it just doesn't work.
jc creative
Reviewed in the United States on December 13, 2013
Like the other review, these are hard plastic and they are a little less than forgiving if the surface is not flat. They work okay but not great.Edit: I'm downgrading the review because the adhesive has been losing it's sticking ability on several of these. I would say don't waste your time. I'm looking for the better soft rubber ones also.Edit again: downgrade to 1, another just fell off.
Recommended Products
$11.95
$ 5 .99 $5.99