Shopping Cart

Your cart is empty.

Your cart is empty.

6-380V 1' Paddle Control Water Switch, Partial Stainless Steel Type Switch 1.0MPa SPDT Contacts

Free shipping on orders over $29.99

$22.98

$ 9 .99 $9.99

In Stock

About this item

  • Adjustable control value with stable action repetition point. class IP54, micro switch life up to 100,000 times. Can fit most equipment.
  • When the rate exceeds the set value, the fluid actuates the vane and microswitch, and the SPDT can connect the circuit and break other circuits.
  • switches are mainly used to measure the dynamic state of liquids flowing through pipelines, such as water, ethylene diluent, and other non-corrosive copper liquids.
  • switches are typically used where interlock or "cut-off" is required.
  • Water switches are widely used in water treatment systems, central air conditioning, water cooling equipment, fire systems and other applications.



Product Description

Paddle Control Water Flow Switch
Paddle Control Water Flow Switch

Specification: Model:HFS-25 Voltage:6-380V Control mode:Paddle Switch type:SPDT Material:304 stainless steel body, copper connector, phosphor bronze bellows Connector:1"/25mm Max.working pressure:1.0MPa Ambient temperature:0~60 Liquid temperature:-10~100(Fluid without icing) Contact life:1000000 times Microswitch Voltage:220VAC Microswitch Current:15A Weight: Approx.416g/14.7oz Package List: 1×Water Flow Switch 5×Paddle 1×User manual

Installation Method: 1.Open the flow switch 2.The switch has been set at minimum flow rate. 3.Press the target to check whether the micro switch can work normally. 4.After the installation, please press the lever of the flow switch several times to check. If there is no "click" sound, turn the adjusting screw counterclockwise until there is "click" sound. 5.The adjustment screw of lacquer seal is only used for the first time to adjust the state of flow switch. 6.Observe three operating cycles to ensure that the switch and the system to which it is connected are operating properly and cover the switch enclosure promptly.

Note: 1.It is absolutely forbidden to impact the wrench on the switch base plate, which will to the deformation and failure of the flow switch. 2.When wiring or debugging,cut off the power supply. 3.When wiring,it is absolutely forbidden to adjust any screws other than micro switch terminals and grounding screws.And connecting the wire carefully. 4.Special grounding screws must be used for wiring, and installation screws cannot be removed. 5.The blade of the flow switch cannot contact with the inner wall of the pipe and other throttles in the pipe, otherwise the switch cannot be reset normally.

01

ABS Shell Material

ABS sturdy material, rainproof and dustproof, beautiful and generous.

02

Adjustable Screws

One-word micro-adjustment screw, easy to push downward. Cross fine adjustment screw, easy to push inward.

03

Thread Material

The threads are made of brass, with different diameters for each model.


john slayton
Reviewed in the United States on September 5, 2024
The threads on the pipe portion of the valve were represented as being NPT (National Pipe Thread, the American standard). THEY WERE NOT. I was told the thread pattern was British, useful only if you're in Britain. I won't be buying any more products of this type through Amazon.
Alfonso garibay
Reviewed in Mexico on August 21, 2023
Es de similares características de contrucción que cualquiera de los más costosos.
William p.
Reviewed in the United States on December 26, 2023
muy facil de instalar. funciona perfectamente
C Moreno
Reviewed in Mexico on November 13, 2023
Buena sensibilidad del SwitchRosca adecuada no se batalla para ensamblar
Recommended Products