Shopping Cart

Your cart is empty.

Your cart is empty.

62-23543-01 Flame Sensor Rod Furnace Sensor for Gas Furnace Sensor Fit for Rheem (4 pack) LUXRILIX

4.6 (9) Write Review
Free shipping on orders over $29.99

$13.47

$ 6 .99 $6.99

In Stock

1.Size:4


  • Replacement Flame Sensor Model：62-23543-01,62-23543-02,62-23543-03,62-23543-04
  • Applicable Circumstances：Detect when the burner flame ignites and send a signal to the control panel to stop the ignition. Length (mounting flange to sensor tip) 2-1/2", length-sensor offset: 1-9/16". Angle sensor offset: 90 degrees. Termination 1/4" male thread quick connect
  • Excellent Quality: made of high quality and hard wearing metals and ceramics, well tested and durable
  • Easy to install, cost-effective: You can easily replace damaged sensors by following our installation process. Help you save equipment costs!Before installing this component, disconnect the power and turn off the air source. Wear work gloves to protect your hands.
  • About LUXRILIX: We hope you love our furnace flame sensor! But if for any reason you're not completely satisfied, we're here for you. If you're not sure if this flame sensor is correct for your device, please don't hesitate to reach out to us. We're always happy to help


Product Description


Daniel W Carter
Reviewed in the United States on March 7, 2025
great product at a good price
T MUD
Reviewed in the United States on January 6, 2025
Economical Exact Replacement for the original rod in an older RUUD furnace Model 80PS07EBR01Works Perfectly as of day one. Will update if premature failure
SMITTY
Reviewed in Canada on July 18, 2024
good product
Samuel J Finfrock
Reviewed in the United States on June 15, 2024
Needed a new igniter. These were a deal for future use. Great product.
Scott
Reviewed in the United States on February 28, 2024
Very cheap and easy to install.
Meticulous Mechanical
Reviewed in the United States on October 6, 2024
Out with the old and 8n with the new.
Troy W
Reviewed in the United States on January 20, 2024
I've been having problems with our furnace shutting off during the startup process. I would clean the old flame sensor and it would work for months...then weeks...and then, lately only days. So I finally got around to ordering these new ones. The install took less than 5 minutes and the furnace has been working great ever since. No issues at all.
Douglas E. Swagger
Reviewed in the United States on December 19, 2023
Flame sensors Right ones and great price
Mad Dad
Reviewed in the United States on April 8, 2023
Not an exact fit but does the job. Please note that rods do not band. They break so if yours should be on a 45° angle this is not the one for you