Your cart is empty.
Your cart is empty. ULN2003 Stepper Motor Drive Module Green PCB:
On-board ULN2003 motor drive chip
Power supply: 5V
On-board 4-way signal indicator
PCB board size: 34mm x 32mm, Weight: 7g
With a standard interface, when used directly pluggable.
A, B, C, D four-phase LED indicates the status of the stepper motor work.
Deceleration Stepper Motor:
Note: the motor can only turn when it is powered on.
Type: 28BYJ-48
Diameter: 28mm
Weight: 33g
Cable: 23cm
Voltage: DC 12V
Reduction ratio: 1/64
Step angle: 5.625 X 1/64
No-load Pull in Frequency: >600Hz
No-load Pull out Frequency: >1000Hz
Stepper motor with a standard interface, when used directly pluggable.
Five-line four-phase can be used for ordinary ULN2003 chip driver, connect to the 2 phase , support the development board, with convenient use, direct docking.
Package included:
6 X ULN2003 Stepper Motor Drive Module
6 X 28BYJ-48 Stepper Motor
S Miller
Reviewed in the United States on July 27, 2024
These motors aren't powerful, but they're perfectly fine for display applications like gauges and clocks.
Mike W.
Reviewed in the United States on June 10, 2024
The stepper motor board (ULN2003) is easy to program and can be utilized in several different configurations and various motors. The included stepper motors (28BYJ-48) are a useful touch for various small electronics projects and work nicely but they are some of the least expensive and least powerful steppers you'll find on the market.So where can you use it? One such project that I played around with using these steppers was actually a 3D printed clock. It was quite simple to create and found the project on instructables which is using an arduino base board. The programming went quick and easily and everything worked as designed. Quite happy with this little setup and I'm sure you'll find several additional projects that you could create with these as well!
Customer
Reviewed in the United States on October 29, 2024
They're okay for light loads. I had to print some planetary gears in order to direct drive the rods in my curtains, but they accomplished the project. A little slow but I don't notice bc generally the blinds are open when the sun comes up and closed when the sun goes down. Perfect motors for cheap blind automations.
Recommended Products
