Your cart is empty.
Your cart is empty.Product Description
Wishiot GY-521 MPU-6050 MPU6050 Acceleration Sensor
The InvenSense MPU-6050 sensor contains a MEMS accelerometer and a MEMS gyro in a single chip. It is very accurate, as it contains 16-bits analog to digital conversion hardware for each channel. Therefor it captures the x, y, and z channel at the same time. The sensor uses the I2C-bus to interface with the Arduino
Note：See product documentation for how to use with the Arduino IDE
Parameters
Use the chip: MPU-6050
Power supply: 3V-5V
Communication modes: standard IIC communication protocol
Chip built-in 16 bit AD converter, 16 bits of data output
Gyroscope range: + 250 500 1000 2000 ° / s
Acceleration range: ± 2 ± 4 ± 8 ± 16 g
Pin Definition: VCC, GND, SCL, SDA, XDA, XCL, ADO, INT
Pitch:2.54mm
Board size : 20mm(length)*16mm(width)
Ridsh Rimski Casimir
Reviewed in Canada on June 20, 2023
One of the 5 was not working out of the box
Jay
Reviewed in the United States on September 6, 2022
The IMU works great with my Teensy4.1 board on a custom drone but use caution when choosing fasteners. I broke capacitor c11 while tightening the board with an M3 screw. My picture shows a flat head Philips M3 screw for reference.
TimBit
Reviewed in Canada on February 7, 2022
It's not what I wanted to buy, but with the chip prices, I had not choice. They do work for what I needed. Thanks, came in on time.
Jason.D
Reviewed in the United States on December 25, 2021
The accelerometer and the gyroscope works fine, but the temperature sensor is not that accurate. since it is a bonus feature it is still a good price.
Recommended Products