Your cart is empty.
Your cart is empty.
- Hex Flange Nuts
- Class 10 Zinc. DIN 6923
- Diameter: 14mm
- Thread Pitch: 1.5
- Height: 14mm
- Wrench Size: 21mm
- Flange O.D.: 29.9mm
- 5 Per Package
Paul S. Spasske
Reviewed in the United States on September 9, 2024
The welded bung nut on my compliance bushing broke loose when removing the bolt.This was the biggest flange nut I could find for the bolt and worked great.
New Jersey girl
Reviewed in the United States on September 12, 2024
Stronger than OEM perfect fit for2000 f250 4x4
Paul
Reviewed in the United States on July 18, 2024
As described
Todd Buckendorf
Reviewed in the United States on March 25, 2024
Fit perfectly and holding up so far on my control arm without any concerns at 194 ft-lb
Brad Merrill
Reviewed in the United States on December 12, 2024
As described
Russ
Reviewed in the United States on October 23, 2024
lost a control arm nut these replaced them thank you
Texas Bigfoot Rangers
Reviewed in the United States on April 1, 2024
Tough finding this size for my 7” lift aftermarket tie rods. Good to go now
'standard
Reviewed in the United States on August 5, 2021
Quality is fine. Worked for me. I caught my upper control arm had lost its nuts. Found these on Amazon. Lowe’s, depot, didn’t have. Its more of an automotive thread. Auto parts may have. Or good hardware store. Figured I’d take the running around out. I haven’t found a good size washer to replace the stock one. Not sure I need to. Time will tell. I double nutted and blue loctite on outside nut. Put one on driver side for good measure. But I’m sure it’s only a passenger side problem. When arm articulates upward it can loosen on passenger side. Added some pics of bolt not in place. Scary. Especially since I just took family on a 500 mile trip on highway. Should fit most Toyota upper control arms. This is on my Lexus GX460, parts are same as 4runner. Check your nuts peeps. But if your here, you may have already.
Recommended Products
