Your cart is empty.
Your cart is empty. Maexxna 40pcs copper oxide Shelf Support Pegs with Hole
We are committed to providing high quality hardware products.Maexxna 40pcs copper oxide shelf support pegs solves the shelf support problem, giving you a better use experience.
Product details:
Copper Oxide Shelf Support Pegs -- 40pcs
Choose our products,
You will receive 40pcs copper oxide shelf support pegs with hole.
You will perfectly complete the work of supporting shelf.
You will have the best shopping experience.
The pegs length is 11mm, make sure your board thickness exceeds the pegs length.
Lee in VA
Reviewed in the United States on June 7, 2024
These are strong and so much better then what came with my kitchen cabinets.
Steve Constantinides
Reviewed in the United States on December 25, 2024
Excellent in appearance and strong in function
Katy
Reviewed in the United States on December 24, 2024
I couldn't find any of these pegs in the big box stores that were this size and this color. These worked great!
Robert M.
Reviewed in the United States on November 6, 2024
The pegs are fine, but they require a 15/64" drill bit for correct hole size vs 1/4 " as described on the Amazon website. Lowes does not carry any metric sizes but Home Depot does. So I had to spend another $10 bucks to use these pegs.
Sean DeYoung
Reviewed in the United States on November 30, 2024
Nothing to complain about. I got the brass/bronze ones and they are very pretty and stylish
maria pavlopoulos
Reviewed in the United States on October 22, 2024
Perfect size n color.
Online customer
Reviewed in the United States on April 29, 2024
These replaced some clear plastic brackets that have been supporting shelves for quite a while. When one broke I decided to change them all to metal. The bronze colored ones blend in nicely with wood shelfs and are solid. The only downside is that the pin is just slightly larger than the standard plastic one so you have to oversize the hole just a bit so the new pin will fit. I measured the width of the side supports and taped the drill bit to have a guide when to stop drilling. I did not make the hole too big, just enough to start the pin into the hole then tap it in gently with a small metal rod and hammer. Take your time and don't rush it. The pin should be a bit snug and once in its pretty rock solid. Also make sure you orient it the right way as the brackets can be 180 out.
Customer
Reviewed in the United States on July 24, 2021
overall good product just seem a little loose might have been wrong size
Recommended Products
