Your cart is empty.
Your cart is empty.The 4-Point Jack Adapter offers the versatility to lift just about anything that is large, heavy, and awkward with your jack. Easily converts most jacks to safely hold a solid axle, 3rd member, driveshaft, transfer case, transmission, bumper, fuel tank, etc... Modular design allows easy configuration for different parts. It has threaded supports all around and includes a wrench to make adjustments with weight on it. It has a 3/8" thick base plate with 1/2" bolts which hold the U-slot bars. This design makes it easy to center the jack under the load, then move the supports to find pick points. Threaded supports are 8" long 3/4" dia. all-thread that can be replaced with custom lengths.
We went all the way back to the drawing board for the new 4-point Jack Adapter. Our 1½" adapter pin that replaces the floor jack saddle allowed for the new design that allows you to use 911 Motorsports Floor Jack Extensions.
cathy
Reviewed in the United States on September 7, 2022
Used it to put rear end in van. It works great.
Ridgerunner
Reviewed in the United States on September 7, 2020
Like it
john t thompson
Reviewed in the United States on May 6, 2020
NOTHING to dislike. This 4 point jack/stabilizer is very well built, super heavy duty and dare I say it, “pretty”. The finish is super-high quality and the unit came packed extremely well. Don’t hesitate. Buy this without concern if you’ve the need!
Recommended Products
