Smoke Detector Carbon Monoxide Detector Combo, 2 in 1 Smoke and Carbon Monoxide Detector

Smoke detector carbon monoxide detector combo has 2 in 1 protection, using high sensitivity photoelectric sensor to detect smoke and high stability electrochemical co sensor to detect carbon monoxide.

Once carbon monoxide or smoke reaches its alarm sensitivity level, both sound alarm and LED indication will be given out to warn you to take action to avoid it.

LCD screen of this smoke and carbon monoxide detector doesn't have a constant display, it shows blank in a standby mode. Or in order to preserve the battery there is no constant display, but it always keeps a standby mode. It will show number after batteries installed or when you press the test button, or when dangerous levels happen. Standby mode means no light on the screen, it will not disturb you when you need to sleep.

Reset Instruction:

If the smoke and carbon monoxide detector beeps continuously after a smoke or carbon monoxide test, the beeping will not stop until the sensor's smoke or carbon monoxide concentration recovers. This is no need to reset.

If the smoke and carbon monoxide detector beeps continuously because of misinformation or fault, please try to reset.

When you receive our smoke alarm first time, after inserting batteries, sometimes it may keep beeping because we did a factory test before, so the battery was unplugged without the charge inside being drained. So you need to try to reset.

Reset Method:

1. Remove batteries, then press test button several times so that excess electricity will be discharged.

2. Press and hold the test button, at the same time, install batteries. Keep pressing and holding until led light flashes, then release your hand, this smoke and carbon monoxide detector recovers.

If reset still doesn't make it recover normal, please do not hesitate to find us, we will try our best to help you solve problems.

Precautions for Routine Maintenance of This Product:

1. In order for the smoke alarm to always maintain a normal working condition, this product requires regular maintenance.

2. Clean the smoke detector regularly every week with a soft bristle brush or hoover.

3. Because grease and dust can block smoke and carbon monoxide from entering the sensor, if this alarm is installed in a kitchen, garage, or hearth where there is a lot of grease and dust, install the product at an appropriate distance away from grease and dust.

4. We recommend that the batteries should be replaced regularly, usually every 3 months, to prevent the sensitivity of the product from being affected by low battery power.

5. In order to maximise the success of the smoke or carbon monoxide going into the smoke inlet, we strongly recommend mounting the alarm on the wall or ceiling, as these places will bounce the smoke or carbon monoxide into the side inlets contact sensors, ensuring that the product will be able to sense them faster and in a timely manner.

6. Warm Tips: This smoke and carbon monoxide detector has an alarm threshold, only when the concentration of smoke or carbon monoxide reaches the alarm threshold, the alarm will be alarmed. This alarm threshold is also to prevent false alarms.

Detection at Any Time