Your cart is empty.
Your cart is empty.Product Description
HOW TO USE?
FOR THERMOSTATS
- Shut off the circuit breaker power supply
- Install any wire from the 24 volt adapter to the "C" end and another wire to the "R, RH or RC" end.
- Plug the power adapter into the socket
- Open the circuit breaker power supply
- Install the panel on the thermostat
HOW TO USE?
FOR DOORBELLS
- Keep adapter unplugged
- Install wires from 24 volt adapter into the terminals for your doorbell unit (any wire can be connected to any terminal)
- Plug the power adapter into the socket
- Put doorbell face plate on housing unit
- Power up and verify your doorbell is receiving necessary power using the accompanying application
Tim K
Reviewed in the United States on January 26, 2025
Bought this for my Ring doorbell camera. Really like the long wire.. plugs into outlet. Works good !!!
christine e pecha
Reviewed in the United States on January 21, 2025
Added to my new wifi thermostat, plugged in and everything work as it said
kay kraf
Reviewed in the United States on August 24, 2024
This product has a long cord, which is very convenient in the kitchen or in the den when you want to battery up your phone.
C. Melgaard
Reviewed in the United States on July 8, 2024
I tried every possible combination of wires, this will not work with amazon thermostat because the RC jumper has to be in the up position
Paul A Bruno
Reviewed in the United States on February 4, 2024
I have an electric heater wired for heat only with only W and R (aka Rh) wires, a standard 24v thermostat and installed a Honeywell T5 smart thermostat. Note my power supply did not come with instructions, which might be forgiven in that by definition you bought this because you are jerryrigging your way around an odd set up, and it may be impossible to address all the possible installation options. But lots of guidance available on line.For mine, in the new thermostat I simply needed to remove/disable the jumper between R and Rc terminals, connect the power supply to the now stand alone Rc and C terminals. Perhaps I was lucky in my first choice, but polarity does not seem to matter here. Then connect the existing R and W wires to the new thermostat as labeled.Smart set up then was as advertised for the thermostat.
FutureGamingUSA
Reviewed in the United States on December 21, 2024
This cable is freaking LONG, long enough I ran it through the wall and just plugged it in next to my furnace lol. Worked great for my smart thermostat 🤷♂️
B.S.
Reviewed in the United States on April 30, 2024
Works, but the plastic box cracks open after one of use. Item is not good quality. Ring wall plug is better quality !
Chayo
Reviewed in the United States on September 7, 2022
I haven’t been able to use it as it’s summer, but it was easy to install and looks much nicer than the one we had before
Recommended Products