Your cart is empty.
Your cart is empty.Lawanda Cummins
Reviewed in the United States on March 3, 2025
Good filter
William L. Whitley
Reviewed in the United States on March 13, 2025
A great replace filter, much less expensive than or branded ones. Plus, these are washable.
gerald
Reviewed in the United States on February 24, 2025
a good value
BobN4deals
Reviewed in the United States on February 14, 2025
Fits my old Shop Vac perfect, but there was no brush as shown in the picture. Therefore 4 stars.
Debra Romero
Reviewed in the United States on March 19, 2024
They were so pretty and white. They're easy to clean with a blower. I use one to blow that you use on an air mattress. They fit tight so it's hard for me to put on and take off. I'm handicap. My shop vac is a life saver for keeping my floors clean. We got 2 filters for a good price. With the new filter my vac is sucking as hard as ever. I recommend this product.
Jim L.
Reviewed in the United States on December 14, 2024
I have two shop vacs that use this size filter and these work. Economical and in conjunction with the bag pre-filters, they do the job. Nice tight fit and seem well made. Recommended
Jennifer Mahfood
Reviewed in the United States on November 14, 2024
Works just as well as the original! No complaints
Mark
Reviewed in the United States on November 20, 2023
These cartridges were bought as a replacement for the ShopVac 90304 filter. When I tried to install the filter, it would not go on. As I tried to push the filter, the wall would start to buckle. It was just too tight of a fit OR the wall of the filter is not ridged enough to handle the necessary force when pushing. Work around: A small amount (light film) of vegetable oil on the two seating surfaces allowed the filter to slide over the receiver without too much force. Now, the retainer that is supposed to be inserted into the bottom and rotated slightly to keep the filter in place was another problem. I was able to insert the retainer ALMOST fully, but not able rotate it to the locked position. Considering the tightness of the upper seal, I decided to leave it at that and check on the filter from time to time as needed. Bottom line: The filter will work. The manufacturer should increase the inside diameter by 1 or 2 mm.
Recommended Products