Your cart is empty.
Your cart is empty.Product Description
Stan B.
Reviewed in Canada on June 29, 2024
Works well with all my scopes
Myles M.
Reviewed in Canada on March 27, 2024
I have not used them yet. Seems like good quality probe. Will use on my diy oscilloscope when it is built.
niteman131
Reviewed in the United States on January 29, 2024
I got 2 of these HV Probes, mostly for working on vacuum tube amplifiers. Most tube guitar amps have voltages above 300 VDC (maximum voltage for my 10x probes and scope inputs), so now I can safely probe HV circuits without worrying about blowing up my oscilloscope and 10x probes ! Of course, with the 100x attenuation of the HV Probes you lose sensitivity for looking at the smallest signals (ripple, noise, and low level audio), but I can see just enough of the signals of interest when I set the scope to it's most sensitive Volts/Div setting. The 60 Mhz bandwidth of these probes should be more than sufficient for audio and even most TV/Video work.These x100 HV probes are a "must have" for my electronic workbench (I should have purchased them long ago, but better late than never).
José M.
Reviewed in Spain on November 3, 2023
Cumple todos los requisitos para poder analizar y medir señales de muy alto voltaje, por ejemplo en fuentes conmutadas o la propia señal de la red eléctrica, así como todo tipo de circuito electrónico que tenga una tensión muy elevada, tanto en alterna cómo en continua.
Bob
Reviewed in the United States on October 11, 2023
Work great with a couple vintage O-Scopes no issues thus-far.
aticos
Reviewed in Spain on December 25, 2022
La sonda funcionacorrectamente y las medidas con correctas
TechGuy1337
Reviewed in the United States on January 1, 2022
I did not expect this probe to really have 60Mhz of bandwidth, and it may not, but it performs really well into the ~5MHz range with 0 noticeable decay. Well worth the money. I use it often for tube amplifier debugging in the 200-500V range.
Boris
Reviewed in Germany on May 9, 2021
Sehr Gut. Nutze diesen Tastkopf um Röhrenverstärker zu vermessen.
Mark Twine
Reviewed in the United States on February 27, 2020
Disclaimer: Take proper care when measuring 120 V outlets!I had previously been trying to measure 120 V Mains waveforms with no success. According to my oscilloscope's specs, it should have been able to handle such voltage easily with a 1:10 probe, but when I attempted to measure this, the top/bottom peaks got cut off, only measuring a range of +/- 50V. Turns out this is an issue with the software's graphing or processing limitations rather than a problem with my oscilloscope. Once I switched to the 1:100 probe, the waveforms looked great (in the sense that I could see the full waveform, not in the sense of being a perfect sine wave). Happy scoping!
Dan Buchanan
Reviewed in the United States on November 3, 2019
Great price, fast shipping.
Recommended Products
$229.99
$ 99 .00 $99.00