Your cart is empty.
Your cart is empty.Jeremy lacombe
Reviewed in the United States on September 6, 2024
I bought this for my machine shop. Quality was very good and cuts good clean threads. Very nice tap!!
Papawheelie81
Reviewed in the United States on August 29, 2024
I bought this to use until my better replacement came in, and it does a great job. Can't speak to the longevity of it, but its sharp, and does great
Bobo Lee
Reviewed in the United States on July 7, 2024
Nice tap and good precision thread cut for my project .
Joanna
Reviewed in the United States on July 22, 2024
There's not a lot.I can really say about this.It does what it says works as described
Zac
Reviewed in the United States on July 2, 2024
Works great if you need to chase threads to install a buffer tube.
Donald Terrien
Reviewed in the United States on May 21, 2024
Very well built.
John D
Reviewed in the United States on November 14, 2024
Surprisingly it's of very good quality and was able to quickly and easily tap the end of a tie rod.
Old Crow Depot
Reviewed in the United States on October 12, 2024
Product was well made and all cutting flutes were sharp and hard. I used it to chase the threads on an early 1930's Japanese military rifle receiver which was being rebarreled and it did the job quite well. This rifle had an actual thread of 1.025" x 14 and by using a wood dowel rod as an adjusting wedge it allowed the 1"x14 tap to do its job in a controlled manner.
Recommended Products
