Your cart is empty.
Your cart is empty.Air manifold block is the starting points for air manifold systems. Can be mounted in line or at a take-off point easily with the 5/11" diameter threaded hole design. Single Row Manifold type and Corrosion Resistance material. It takes one line of air from a pump, air cylinder, compressor, vacuum engine, or other such system and splits it into many of them. All ports are in the same size, so that you can use it as a 1 in 6 out, 2 in 5 out, 3 in 4 out and so on to meet your own requirment.
David J Jackson
Reviewed in the United States on January 10, 2024
Threads were all good. Good quality block for your air manifold. Enough space between holes to easily wrench your fittings into it. Would buy again for sure
Carolyn Philemon
Reviewed in the United States on July 17, 2022
Great Price. Fast shipment
Janet M. Stapleton
Reviewed in the United States on May 4, 2022
Don’t bother with these. Absolutely worthless especially if you need to pressurize the fittings and lines. I’ve used many of these over the years with ongoing success but….. these should stay on the Chinese container ships. I would rename them aluminum scrap or paper weights or maybe door stops. I used in a pressurized air system with everything installed correctly , (again I’ve used other versions for years without problems) and EVERY fitting in the block leaked with less than 30 psi air. Don’t believe they seal with NPT and even if so there is only 2-3 threads to screw into. Useless ! Look for Parker Hannifen or other well made brands if you need these.
Jake
Reviewed in the United States on February 11, 2022
1/2 npt will thread into it fine but your fitting will bottom out. This is not tapered threads.
NM
Reviewed in Canada on July 30, 2021
The wall is thin so only two full threads are available to seal. Also, once the NPT fitting is inserted, it reduces the air flow significantly.
Recommended Products
$104.39
$ 48 .99 $48.99