Shopping Cart

Your cart is empty.

Your cart is empty.

12' Press Brake Attachment/Press Brake Attachment For Standard 12/20 Ton Hydraulic Shop Presses

Free shipping on orders over $29.99

$158.99

$ 65 .99 $65.99

In Stock
  • Create complex shapes
  • Attaches to Most Standard Hydraulic Shop Presses
  • Upper die mounting cup Inside Diameter 1-7/8inchs/48mm
  • Overall Dimensions:14.5" Wide X 7.5" Deep X 10" High
  • Bottom Die Overall width: 2.25"
  • Bottom Die Overall Height: 1.75"
  • Max Width Capacity: 12"
  • Brake Range: 0˚–90˚
  • Max Thickness (mild steel):3/16" x 12" Width ,1/4" x 6" Width ,5/16” x 2” Width


The Press Brake Attachment is a precision engineered metal working tool designed to produce accurate, variable length bends in angles up to 90° in mild steel and aluminum in widths up to 12” and thicknesses up to 3/8”.


Gary in n. california
Reviewed in the United States on January 8, 2025
Arrived on time and packed well.Easy assembly. Right away I tried bending a 3 " wide piece of 3/8" thick mild steel I had on hand.It did it great - there Was some pumping of my 20 ton jack but the metal Bent.The break was well supported during the test - this is important.Then upon tool inspection post use there was No bending/deflection/dulling of any parts of the tool.Very happy and would buy again today.
John E. Bryant
Reviewed in the United States on September 22, 2024
Put some 90 degree bends on 1/4in stock, 2.5 in wide. Very pleased with the results!
John
Reviewed in the United States on July 7, 2024
Purchased to bend 1/8" aluminum, nice accessory for the HF 20 Ton Press. Easy to assemble, install and align. Machined surfaces are straight and metal is clean and defect free. Evaluated three options from photos, different manufacturers $156 - $249 price range. There appears to be absolutely no difference between the products other the brand name and labeling. Went with lowest cost option, no regret.
David Florence
Reviewed in the United States on December 15, 2024
Some in other reviews complained that it was difficult to assemble. So when I assembled it I did it with everything loose and it fit together very easily. Then tightened it all up after fitting it together. First bend was a compound with some 3” wide 3/16” steel in a cheap 12 ton press and this brake worked so well. Bends went in easy and came out perfect. Great product for the price. Would recommend to any one needing a press brake. Easy to assemble and easy to use.
Customer
Reviewed in the United States on October 31, 2024
Everyone needs one of these press brakes in their shop. Beats the heck out of a vice, torch, and hammer to bend metal.
Paulie
Reviewed in the United States on October 11, 2024
Worked like a charm bending 1/4'' aluminum
Brophman
Reviewed in the United States on October 10, 2024
this works perfectly in my little 12T press.very pleased
Joe G
Reviewed in the United States on August 29, 2023
Was looking at the more expensive ones that are out there but then I seen this and I figured I'd give it a try I'm glad I did. Had to make the holes a little bigger for the spindles on the sides because the brake would not slide on them up and down good. After I did that works like it shut happy with the product. If I didn't have to drill the holes I would give it five stars.
Recommended Products