Your cart is empty.
Your cart is empty.Taryn and Jake
Reviewed in the United States on October 18, 2024
Perfect for holly 850 double pumper. Choke clears now without any issue. Raised air filter just enough to clear linkage but not hit the hood
Bill
Reviewed in the United States on April 4, 2024
The spacer fit perfectly on my Holly double pumper carb and modified the air cleaner hight just right. Great buy!
Darrell
Reviewed in the United States on April 20, 2024
It's a fine spacer, dimensionally fits the air cleaner and the carb, but it doesn't allow the air cleaner to just sit on it in alignment with the carb. I have to hold it down when tightening the nut on the cleaner to ensure that it stays in line. Otherwise good product.
Gary Kachur
Reviewed in the United States on May 21, 2022
I remover the spacer under my Edelbrock carburator and needed this spacer to keep my air cleaner at the right height. Works great, fit perfect.
Danny New
Reviewed in the United States on October 18, 2022
Used the 1/2" spacer to keep my factory GM breather after installing the edelbrock 1406. Use on my 350 and 327 engines both.
KingKoolDaddy
Reviewed in the United States on September 4, 2021
You get what you pay for, should have bought name brand. This is a cheap, plastic 2" spacer, and the breather 'teeters' atop it. Tighten your breather nut just too much and it'll slip to the side. I made it work, but barely. I don't recommend
Sandra McNeely
Reviewed in the United States on February 24, 2021
Bought this to get my air cleaner above the top of an hei distributor. You will need to have some under hood clearance to use this. I have an 81 CJ 5 with a sbc. I am using the eps manifold with a holley carb. The air cleaner would hit the distributor before I installed the spacer. I suppose you could trim it if you wanted. It is made of plastic.
Scott Taylor
Reviewed in the United States on December 6, 2021
If you need more clearance for choke or throttle linkage, or you want to move the breather up closer to the hood for a scoop, this is a cheap and easy way to do it. Perfect fit for a standard 4bbl setup.
Recommended Products
$18.99
$ 8 .99 $8.99