Your cart is empty.
Your cart is empty.Yukon Gear & Axle manufactures a full line of top quality small parts to complete any job including ring gear bolts, crush sleeves, pinion nuts and washers, axle studs, thrust washers and much, much more. For all your differential small parts needs, look no further than Yukon.
Slapda’dappy
Reviewed in the United States on September 1, 2024
Got these when I was rebutiling my axles on my XJ. Cleaned up the axle and look great - the small things make a difference!
Ken
Reviewed in the United States on July 22, 2024
Perfect. The original ones had cracked. Ordered this, arrived as scheduled. This solved the issue and was a good buy.
Gunmetalbluejeeptjs
Reviewed in the United States on April 30, 2024
Put on my axle shafts for my 98TJ but the new shafts were thicker than factory so the the dust shields needed to be ground down in the center which I did with a dremel then slipped on
Richard W Marsh
Reviewed in the United States on August 10, 2023
Looked everywhere including dealers and no one had it in stock I installed this on my wrangler yj with disconnect axle assembly and works perfect to keep out the road debris.
Mike+Claire
Reviewed in the United States on May 1, 2023
100% need a heat gun to get these on. Brittle hard plastic when room temp. I could not install on a Yukon chromoly Dana 30 axle without first widening the opening with a drill and then heating with a heat gun.
A. Brose
Reviewed in the United States on April 6, 2023
My old dust protector fell apart when I changed the front hub on my xj. This was a perfect fit. I have had good luck with Yukon products.
Liz Schmitt
Reviewed in the United States on April 13, 2023
Ordered two while refreshing my Dana30. broke both trying to force over bump near end axle that keeps them located. Maybe try some PVC pipe the diameter of your axle shaft to tap them on. OEM is pliable and goes on by hand.
Jimmy
Reviewed in Canada on March 29, 2022
Check the size before you purchase
Cameron
Reviewed in the United States on April 8, 2022
Not much to say. They fit snugly on the axle. I put them on a Chyrsler 8.25 axle.
Customer
Reviewed in Canada on January 6, 2021
Identique à l'original
Gus K
Reviewed in Canada on December 10, 2020
Fits better than the factory (2) piece guard. Slides over axle easily, and stays in position with a slight amount of tension. Typically the factory (2) piece guard releases at one end, and becomes less effective. If this, slightly softer material lasts, it seems like the better option.
Recommended Products
