Your cart is empty.
Your cart is empty.This long reach core box router bit has a cutting diameter of 1/2" and a cutting length of 1-1/4". The shank is 1/4". Core box bits have rounded tips that are perfect for routing channels in cutting boards and producing flutes in columns using solid wood or MDF. Our core box bits are available in various diameters, with a choice of 1/4" and 1/2" shanks. The smaller shank diameter works well in laminate trimmers, while the 1/2" shanks are ideal for deep cuts with full-size routers.
S. McD
Reviewed in the United States on January 1, 2025
Used this bit for 10 seconds and it was already dull and burning the wood. I was using on hard maple though, maybe it would last longer on soft pine..... Ended up getting a better one at the local big box store that worked great.
CB
Reviewed in the United States on September 21, 2024
Did what I needed it to do
Carl Brown
Reviewed in the United States on April 5, 2024
Good bit, not built for cross grain routing.
damicocarver
Reviewed in the United States on March 23, 2023
I needed this size to core out wood to hold 1/2" copper pipe and it worked great. Seems very durable.
brian k
Reviewed in the United States on March 15, 2023
Served my purpose. Blade did burn wood slightly.
Isaac Zapien
Reviewed in Mexico on July 14, 2022
Muy bueno, aun que solo lo he utilizado una vez, para hacer 4 pizas. y trabajo muy bien
Tater
Reviewed in the United States on October 4, 2021
Quality router bit at a good price. You won't go wrong with this one.
Cliente de
Reviewed in Mexico on January 8, 2021
Muy buena marca
Customer
Reviewed in the United Kingdom on January 17, 2021
very good quality
Carlos Alanis
Reviewed in Mexico on May 2, 2020
Muy buena fresa para rebajar, buen filo y excelente balero, no se atora ni nada por el estilo. Corta muy bien y está muy bien centrada.
Geoff
Reviewed in the United Kingdom on February 28, 2020
Do not buy this product. It has just ruined a very expensive item I was making.The cutter is supposed to be 1/4" shank, it isn't! I only found this out after it slipped from the collect and cutter much deeper than it should. Upon retrospectively using my micrometer I found that the shaft measured 6.28mm and not 6.4mm this meant that the cutter could not be gripped sufficiently to operate properly.I will not buy any more Yonico router cutters.
kapiteinterzee
Reviewed in the United States on December 11, 2019
We're building a ply over frame wood boat and used this router bit to round the corners of the center channel of the frames, shown on photos. The Yonico 14965q 3/4-Inch Diameter Core Box Template Router Bit worked as expected making sharp, well defined radii. We were able to precisely and rapidly round all 22 edges with this bit in short order. We highly recommend this drill bit for all types of woodwork where a consistent, quality 3/4" radius is required.
Robert Scott Jr.
Reviewed in the United States on November 29, 2018
I had previously routed flutes in oak newel posts with disappointing results in that there were burn marks at the ends of the flutes, requiring a difficult cleanup. I used a fence as a guide. Having a new set of posts to do I decided to make a template for routing, thus the need for a bit with a guide bearing. At the end of routing 96, 20" flutes I had none of the burning problem I had before.
Recommended Products
$27.64
$ 11 .99 $11.99
$32.99
$ 16 .99 $16.99
$20.40
$ 9 .99 $9.99