Your cart is empty.
Your cart is empty.NC spotting drill. 120 Degree point angle. Made of 8 percent cobalt and high speed steel. For more precise centering work on NC/CNC machine. A larger diameter in respect to the subsequent drilling tool permit to obtain the centering and chamfering simultaneously.
Annie
Reviewed in the United States on November 7, 2023
High quality, very nicely finished. It's not necessary to have a ton of different sizes since they're only for locating where you want to drill. Much better for spotting than center drills because the 120° angle makes a 118° drill go right to the center of the spot without chattering. This spotting drill is very sharp and cuts with ease.
J Ris
Reviewed in the United States on July 10, 2022
I bought this to mark and start the holes when I drilled and tapped the receiver of my Franchi Affinity 20 gauge. This bit is very sturdy and was extremely helpful to getting the holes started and aligned properly.
Customer
Reviewed in the United States on March 13, 2020
These have a nicely ground finish and well packaged, each in a plastic box. I haven't checked them for runout but as a hobbyist they should be fine.
Customer
Reviewed in the United States on January 22, 2020
Arrived as expected. Worked as expected.
Luis C.
Reviewed in the United States on January 19, 2020
Excelentes herramientas par Fadal Vmc4020
B J Cass
Reviewed in the United States on July 5, 2018
EXECELLENT
David F.
Reviewed in the United States on May 12, 2017
Use for CNC spotting(center drill)
Cleavert Guyton
Reviewed in the United States on May 25, 2015
Drill bit works well.
Recommended Products
$76.03
$ 33 .99 $33.99