It is really great, we have it set to automatic mode on the underside of the handrail in the stairs. The motion sensor is very receptive. It doesn't come on in daylight. We can switch it to manual mode if need be. These stairs go up to second floor where the bedrooms are, so not super high traffic area. The lights have been installed for three weeks and I haven't had to charge them yet (except for pre-installation). It was very easy to install. The luminosity is fantastic, the stairwell is well lit up but not too blinding for the eyes. Very good purchase, I will be buying more. The charging doesn't take very long, 3 hours maybe.

حطيتها تحت السرير.. وجدا رائعة .. الحساس ممتاز وسريع الاستجابة,

I purchased this solution as my house is old (built in 1905) and the stairs are dark. I've had guests trip going up and down the stairs so I figured why not light the path for safety. I will break down the review into three parts, motion detection, brightness and installation.Motion DetectionAccording to the instructions, the sensor has a range of 7-10 ft. It's sensitivity is appropriate from proximity as when I get by the stairs, it lights up. The operation is instant on with no pattern and after no motion is detected for 25 seconds it shuts off. One thing to note is when turning off the lights in my foyer, the lights automatically turn on. I don't know if it matters to anyone but I find it helpful as I don't have to get near the sensor in the dark for it to activate. One thing to note is since both ends pass power, when both sensors are tripped, the lights get even brighter.I charged the sensors out of the box and it took a long time to complete charging (the instructions state 2-4 hours). I heard some people had issues with the battery packs not holding a charge after a while so I will update my review after a month to give my experience.BrightnessThe package states it has an output of 220 lumens. As I do not have a means to confirm this, I take it for face value. The strip produces enough light to illuminate the stairs in the dark and in ambient lighting. However, I would prefer it if the strip was a bit brighter for my own personal taste. Further, I feel the LEDs are a bit too spread out and feel it would benefit with a closer set of LEDs or double the LEDs.Note: I chose the 6000k color temperature as I felt it suited my needs.InstallationAs with any project, one must start with prep work by cleaning the surface for the lights to adhere. As this is my house, I went the extra mile. I swept and steamed the stairs from top to bottom. For the area where I adhered the lights, I hit it with a dry wipe then used lysol wipes and let it dry.As I have a landing, I employed the use of another person to hold the lights so I can stretch it out to see both ends and get an idea of placement. Then I peeled the backing of the iron sheets and placed the sensor on the lower part of the stairs. I plugged it up and started peeling the backing off and affixed the LED strip to the staircase (disconnecting once I got the initial part of the strip adhered). When I got to the landing I had to come around so I cut the strip and tethered it with the included connectors. I secured the cord and continued to the last part at the top of the stairs. Once the entire strip was installed, I mounteded the second sensor and the task was complete.I say the installation was fairly easy that an inexperienced individual could attempt it and be successful and the time it took to complete from start to finish was about 30 minutes where most of the time was dedicated to prep work. Adhering the LEDs was the easiest part while the wire connector part (unnecessary in some cases) took a little time to work with as I had accidentally peeled the backing in the area that was going to be connected. It just made things more difficult because the sticky part kept sticking to my fingers or the connector in the wrong area.Final ThoughtsI recommend purchasing these lights as I believe they provide great value for the cost. Unless you're willing to go all out for an illumination solution for your stairs, this simple solution works great! The ability to have the lights powered by battery provides the freedom to mount the solution virtually anywhere.I took as many pictures as I could for an idea of what to expect.

Facilidad para instalar

The media could not be loaded.

We are using them temporarily without the adhesive strip. We are not done with our renovation project and will varnish the railing next year. We do not want to spoil it by removing it. So I can't comment on how well it sticks. I can however say the the product is perfect for our application. It is very bright and the sensor pics our motion very well when going from the bottom or from the top of our stairs. The battery seems to hold the charge well but it has been only a few weeks so we will see how long it last before needing recharging. We are very happy with our choice so far.

Está muy bien para un clóset o armario, se puede prender de forma manual o en automático al estar oscuro detecta movimiento y prende 20 segundos.