Your cart is empty.
Your cart is empty.Product Description
Wires Up To 2500 â (1371° C).
The sleeve can withstand high temperatures up to 2500â using patented insulation technology. The sleeve is halogen-free and non-conductive, resistant to gasoline and all engine chemicals.
Product Description
Length:3.3 or 10 FT. It will work with 90 Degree, 45 Degree, and straight spark plug boots.
Color: Aluminized
Fahrenheit Temperature: 2500 degree.
Materials: Double-Layer High Temperature Fiberglass.
Easy to install: Just slide the big end (with stitching) onto the boot, no complicated operation process, save installation time.
Spark plug wire boots sleeves suit for most types motor vehicles
1.Fits most hot rods and classics engines including for GM, Chevy, GMC, OLDS, CADILLAC, PONTIAC, Buick, Ford And Mopar, Chrysler, Dodge, Plymouth.
2.The Spark Plug Wire Sleeves Can Rest Directly On Hot Headers And Other Engine Components Without Burning, Melting Or Becoming Brittle.
3.Universal fit for most angled & straight boots.
Dca
Reviewed in the United States on September 25, 2024
Easy to cut and use.
Old Racer
Reviewed in the United States on July 1, 2024
I needed this shield for the wires leading to the crankshaft sensor which is next to the exhaust down tube on my race car. Works well
Stephen Frank
Reviewed in the United States on May 8, 2024
Easy to work with , seems to do its job very well. Make sure you use the metal zips to keep it in place ... would buy again if needed. Thank you
Gary Moore
Reviewed in the United States on May 22, 2024
Nice product
Chibi's-Shiba-Adventures
Reviewed in the United States on December 8, 2024
Worked great for PTFE fuel line protection and should prevent fuel vapor lock. Great product đ
kind wife
Reviewed in the United States on October 8, 2024
It worked for our hotrods , helping to cool the fuel , also installed easy ! When cutting across the velcro the thead may come loose . Used metal ties to secure or small rivet end of velco thread or heat resistant glue .
S. Johnson
Reviewed in the United States on October 25, 2024
I used this to insulate the fuel line ofthe 8.1L Vortec engine in my Workhorse motorhome chassis. This build is known for fuel pressure problems, including fuel pump failure and vapor lock.I insulated the fuel supply and return lines near the engine, and where they pass close to the driver's side muffler.The material is easy to install without breaking fittings on lines. It's a strip of aluminized fabric, with velcro on each side. Cut to length, wrap it around the line and press the velcro together. Done.
Fernando Garzon
Reviewed in the United States on April 11, 2024
Good quality thank you.
Recommended Products