Your cart is empty.
Your cart is empty.WeatherTech laser-measured Mud Flaps are custom fit to protect your vehicle's fenders and exterior from rocks, mud, road grime and other debris. No drilling is required, and our Mud Flaps install in minutes.
.L James
Reviewed in the United States on March 8, 2025
BESR Quality !!!
Customer
Reviewed in the United States on February 7, 2025
Make sure if you have factory moldings on 2018 f150 that you be careful what u order
Customer
Reviewed in the United States on August 1, 2024
Look good on my truck.
MADE IN THE USA
Reviewed in the United States on August 4, 2023
These Weather Tech mud flaps fit like a glove and were easy to install. A little bit more expensive than the others but you usually get what you pay for. I would buy again.
Aldain Smith
Reviewed in Canada on September 6, 2021
Nothing
Randy
Reviewed in the United States on July 28, 2021
As always with Weathertech products these fit very well & were very easy to install but one problem is since they are a little thick (for strength I’m sure) they do allow my tires to rub when turning. I do have 33” Toyo’s without a leveling kit though. Not a real big deal & I’m sure they will wear in!!
Ginth
Reviewed in the United States on March 18, 2021
They look nice and do what I want them to. Purchased to keep crap off my retractable running boards and they do that. I have a 2" lift and 285/65/20 Toyo tires on a 2017 F-150 Platinum and hard turns with some bump cause a tiny bit of rub on the flaps. Nothing bad yet, but I only installed them a couple of weeks ago. We did just get over 2' of snow last weekend and I didn't have issues, so I'm happy with that.
Clay Shooter
Reviewed in the United States on February 9, 2021
The install process is a little lacking in detail. There are wettable adhesive protection film pieces included that are labeled well to tell what fender they go on, but the directions on how to place them are non-existant. A simple diagram to give an end user an idea of the intent would go a long ways. After some trial and error, I think I eventually got them on where they are going to provide the most benefit.Also, the hardware included is pretty self explanatory, however, where the protector attaches at the underside of the panel, an additional spacer would make the attachment more secure as the factory trim has a large cavity where the factory fastener installs, the weathertech piece spans clumsily over that dimpled space, placing a great deal of strain on the screw/plastic to hold it in place, rather than having a firm backing to butt up against and rely on the fastener's ability to secure it. A spacer is provided for a different part of the install, so why not this one?Lastly, amazon's listing for this item says it is NOT for the 2020 F150, however, per the manufacturer's website, it is the correct part number and appears to fit exactly as intended for the 2020 model.
Nick
Reviewed in the United States on September 25, 2020
These were reasonably easy to install and feel solid. The rear flaps have an actual bolt on the upper section that goes through whereas the the front flaps only bolt on the bottom. That being said, they both feel secure and are definitely well made. Make sure you order the right ones for your trim. Mine fit my 2020 F150 XLT Sport with factory OEM fender flairs perfectly.
Recommended Products
