Your cart is empty.
Your cart is empty. Specification:
Item Type: Spark Plug Thread Repair Tool
Threaded Pipe Size: M10x1.0 (thread diameter x pitch)
Threaded Pipe Length: Approx. 17.5mm / 0.69in, 12.5mm / 0.49in(Each 5pcs)
Threaded Pipe Material: Stainless steel
Tap Size: M12x1.0 (thread diameter x pitch)
Tap Shank Diameter: Approx. 7mm / 0.28in
Tap Full Length: Approx. 88.7mm / 3.49in
Tap Blade Length: Approx. 29.7mm / 1.17in
Tap Material: High speed steel
Package List:
1 x M12x1.0 Tap
10 x M10x1.0 Threaded Pipe
Peggy Stout
Reviewed in the United States on January 5, 2024
Good
Dave's Travels
Reviewed in the United States on September 9, 2023
It worked for what I needed. An emergency repair on a cylinder that that went straight up and down. Very easy to thread. The tap worked very well with some wd40. I did use some jb weld on the inside threads to hold the insert in. Only a couple miles so far, but its worked great and held up through a couple heat cycles.
mechanic
Reviewed in the United States on March 20, 2023
was not the right picth on the long ones poor quality
sllewnoj
Reviewed in the United States on February 13, 2023
Worked great and still works
Thrift Shop Reviews
Reviewed in the United States on December 1, 2023
Fixed my problem. Normal helocoils didn’t work due to previous owner damaging insert threads. Works great but they need a few notches on the top plus an installation tool. Otherwise you need to use a spark plug to install. The notches plus tool would also help if you need to remove.
Vickie Ybarra
Reviewed in the United States on October 4, 2023
Arrived quickly. Sturdy, good product. Would definitely buy again
Customer
Reviewed in the United States on April 20, 2023
It worked as it says it does just fine
Recommended Products
