Your cart is empty.
Your cart is empty.Featuring 100% aluminized steel for longer service life compared to low-carbon steel, Walker SoundFX® direct-fit mufflers deliver quality appearance and favorable acoustics while mechanical interior joints and spun-locked heads provide durability.
jake
Reviewed in the United States on February 28, 2025
Nice replacement muffler, would buy again at price. Sounds the same as OEM
Wes
Reviewed in the United States on January 4, 2025
This worked for me. I have a 2010 Chevy impala. The one thing I will say is the collar could be a lil longer with that being said you’re going to want to cut off as close to the muffler as possible. I used a 2 1/4 inch muffler clamp the whole job took 15 minutes took longer to gather tools than it did to do the job. I used a reciprocating saw to cut muffler off slid exhaust pipe in to muffler about a 1/2 to3/4 of an inch bolted the hanger back on gave it a good wiggle to seat properly and put the muffler clamp on and let the car down pretty easy and quick overall good value good product sounds great 10 outta 10 would buy again
Junior B
Reviewed in Canada on January 19, 2025
Put on my Subaru legacy 2002 wagon , look like a original one , quiet and it’s for a good Price !
Troy fritz
Reviewed in the United States on January 11, 2025
Once again I'm very pleased with my Dynomax muffler. I've replaced every muffler on every one of my vehicles for 35+ yrs and have never been disappointed
Brian christiansen
Reviewed in the United States on August 4, 2024
Just buy a 2 and1/4 clamp cut the pipe close to the muffler as you can slips rite over the factory pipe. Clamp and or weld and done took me 15 minutes
Debbie
Reviewed in Canada on August 12, 2024
The muffler was exactly what I needed for my car
david
Reviewed in the United States on October 1, 2024
muffler looks good looks like the correct fit havent installed yet so cant comment on sound but guranteed to be better than what i have now should work good
MEM
Reviewed in the United States on September 4, 2023
This muffler fit perfectly on my 2008 Impala. I cut the old pipe as close to the muffler as possible with a grinder and sawzall. The new one slid over the old pipe. I used a muffler clamp that I purchased separately. The whole job took about 45 minutes. I took the rear tire off for easier access.
Jon Marlie Torrey
Reviewed in the United States on May 6, 2023
Good shape, works great
DG
Reviewed in Canada on July 6, 2022
Fits perfectly - works well -- sounds good. Happy customer. What else is there to say??
Wayne
Reviewed in Canada on January 12, 2021
Quite
Steve
Reviewed in Canada on September 9, 2019
The muffler fit like a glove ..... great product...
Michael L Sanford
Reviewed in the United States on February 4, 2018
I used a metal blade in my Ryobi cordless reciprocating saw and cut the existing exhaust pipe as close to the old muffler as possible. Without removing the passenger-side rear wheel it was challenging to cut the top of the exhaust pipe so I ended up cutting all but 1/4" to 1/2", slipped the muffler out of the two rubber isolators on the tailpipe end then "rotated" the muffler a few times to cause the remaining bit of metal to snap.The new muffler's hangers fit nicely into the rubber isolators and the old exhaust pipe slipped into the new muffler with ease. I slid the recommended u-bolt clamp over the mufflers inlet ensuring that the old exhaust pipe was well enough inside then used a deep 1/2" (?) socket to tighten the nuts.It was immediately obvious that the old muffler was long overdue to be replaced. The new one was a direct fit, overall installation time was less than 30 minutes from driving the car up onto ramps, removing the old muffler and down the street for a test drive. My wife commented how she can now hear the wind noise while driving instead of the rumble of the exhaust, I guess I am replacing door seals next.
Recommended Products
$131.99
$ 63 .99 $63.99