Your cart is empty.
Your cart is empty.Vertex 4 Piece 15.5mm (.610")" T-Slot Clamping Nut Kit Specially made downward force for holding thin or small workpieces. Used for milling, drilling and EDM with a T-slot table. Kit includes 4 pieces each with a t-slot, clamping piece and bolts. Quick and easy setting with hex key wrench. Made of hardened tool steel. Supplied in a fitted wooden case. Made in Taiwan. Vertex # CK-3716.
Nick fornabaio
Reviewed in the United States on February 7, 2022
The item is too long to fit in the Bridgeport table slot which is an industry standard they are about an 1 3/4 “long most other T-slot fixtures are between 1 inch to one and a quarter inch so that you do not have to disassemble the entire travel spindle to put these on ,,,and due to that you will have to leave them on the table at all times because you cannot remove them unless you remove the spindle againIf you’re always working on the same item and they are not in your way then you’ll be OK but if you’re working on different things all the time and you don’t want them on the table all the time this will not work because they will be in your way and you can only slide them to the other end of the table and if you have a long parts they will interfere with anything that you have other than that they are made well
Zooks
Reviewed in the United States on March 31, 2020
Great for clamping flat stock
z30
Reviewed in Canada on December 28, 2018
Well made clamp set perfect for holding material securely while faceing. Should have bought them years ago.
Customer
Reviewed in the United States on May 6, 2017
Great Product!, No Complaints, All Good, Delivered On Time, Nice Quality, Would Purchase Again, Would Recommend to Others, Money well spent
Recommended Products
