Your cart is empty.
Your cart is empty.Robert Michael Cargill
Reviewed in the United States on March 10, 2025
Works
frank carcieri
Reviewed in the United States on July 11, 2023
Needed for metric tool I purchased
Austin G.
Reviewed in the United States on July 18, 2022
Collet fits too loose into the nut
Kent R.
Reviewed in the United States on July 15, 2021
I needed this to adapt a electronic edge finder on my mill without removing and installing a r8 adaptor. Allows me to use the same size end mill.
James White
Reviewed in the United States on June 13, 2020
The runout on it is not bad. The edges were polished to the point that they are slightly rounded off. The retension spring is unable to hold the collet in the cap. The collet gets stuck in the body of the chuck and has to be pried out.
eric buchanan
Reviewed in the United States on January 2, 2020
Project wasn't bad but it needed instructions other than that was a good product would recommend
Brian W.
Reviewed in the United States on July 12, 2019
Perfect just as ordered
PP
Reviewed in the United States on May 28, 2019
Run-out at collet edge is over 0.005", and 2" away, it is 0.012". I was planning to use it to hold an electronic edge finder, but it is unusable for that purpose (or any purpose on a mill really). Looking at it a bit more closely, I note an 1/2"x ~100 degrees area of quite rough interior surface, about 1/4" from the edge. There's also an aborted slot cut on the back end.Sheesh!
Recommended Products
$23.42
$ 10 .99 $10.99
$47.49
$ 24 .99 $24.99