Your cart is empty.
Your cart is empty.This small, field-proven connector for printed circuit boards is reliable and has a large current carrying capacity. It can be used with a wide variety of signal, power supply, and output circuits that appear in consumer electronic products.liul.
M. Gabel
Reviewed in Germany on May 24, 2024
Es sollten eigentlich 100 Stück drin sein, es waren jedoch nur 98 Stück in der Verpackung und noch dazu waren einige verbogen.
Val Customer
Reviewed in Canada on April 16, 2024
Pros: contacts are as described.Cons: received 96 contacts (instead of 100)
D
Reviewed in the United Kingdom on October 4, 2023
Very well made and a perfect replacement for the missing connectors on my datatool alarm immobiliser connecter.
Customer
Reviewed in the United States on March 21, 2021
I needed to replace the cables on my heated printbed to allow for more current and cooler wires than the factory cable allowed. These were just what I needed to terminate the wires for use in the connector supplied by the heated bed manufacturer.
Addict145
Reviewed in the United States on August 1, 2020
Had my windshield replaced by the famous "come to you" company. Since I'm not driving much, I didn't notice the antiglare mirror quit working after I rated the work. To be fair, you have to disconnect it from the old windshield, which means it hangs for a few minutes, and the wires were 14 years old...pretty deteriorated from the sun. Anyway, the wires became disconnected on the plug. I cut off the rest of the wires, and pried these out. Took a while to figure out the size I needed, but this fit the bill! Was tough to crimp in the tight space between the windshield and mirror, but this worked well!!
Sai
Reviewed in the United States on April 29, 2018
Works as intended
Recommended Products
