Your cart is empty.
Your cart is empty.Product Description
Beam Shaft Coupling
Transmitting torque between two shafts while allowing for angular misalignment, parallel offset, and even axial motion, of one shaft relative to the other
Introduction of Shaft Couplings:
Know the Size You Need
We provide various kinds of rigid flange coupling for choosing. Please check the correct size: d1, d2, L, and D before purchase
Applications
Widely used in drive systems for encoders, instrumentation, lead screws, small pumps, feed rollers, and anywhere light to medium duty torsionally
Helical Parts
Absorption of parallel, angular misalignments and shaft end-play by spring action
Alessio
Reviewed in Italy on December 29, 2021
Buon prodotto giuste sia le misure che tutto
4nonCa00D
Reviewed in the United States on June 1, 2020
Nice product. In using it on my 3d printer project.
Jeff Stauffer
Reviewed in the United States on February 5, 2019
I have tried several couplings for my CNC router and this one seems to be holding up better than the others. The fact that is is fairly solid with only a minor amount of give I think helps it be more sturdy.
Stickler for Accuracy
Reviewed in the United States on January 5, 2019
Perfect Fit for 6mm motor shaft
Breht O.
Reviewed in the United States on March 28, 2018
unusable garbage broke hex wrench and wouldn't tighten to rod
Peter T.
Reviewed in the United States on October 20, 2018
I needed very tight tolerance on this part, and while i understand it's a cheap part, it wasn't very close. I had a motor hanging in space (supported only by it's shaft) acting as a regenerative brake. This meant any misalignment had the rotor oscillating around - not good. I ended up machining my own that was much more concentric and parallel.
J. Stern
Reviewed in the United States on January 9, 2018
Came with missing setscrew !! Cannot find M3 replacment with small enough head to fit. Complete waste of $
Russell 1
Reviewed in the United States on November 29, 2017
THE HOLES ARE NOT INLINE
Bob Loblaw
Reviewed in the United States on October 5, 2017
Coupling has a large amount of run-out (>.01") and the 5mm bore was not finished all the way down. Had to drill the last 1/16" of the bore to allow full insertion of the motor shaft. The clamping screws also do not provide sufficient torque for clamping to nominal shaft sizes. Both threads failed prior to the coupling locking onto the shafts.
Recommended Products