Your cart is empty.
Your cart is empty.Product Description
The size of the header pins should correspond to the same of the header holes, otherwise the connection is not tight enough and easy to loosen.
Can be cut according to different needle number requirements to achieve the actual number of needles used
Choose the header according to the required number of pins and the pin spacing, and insert it directly into the breadboard to connect or form a connector with the header to achieve the purpose of connection
9989
Reviewed in Japan on September 3, 2024
切り離す際は薄めのニッパーで一気にやると綺麗に出来るようです。はんだ付き良好です。
G. A. Jones
Reviewed in the United Kingdom on May 12, 2024
These right angled pcb pins were just the job in connecting up a number of iot modules.
masa
Reviewed in Japan on December 11, 2024
以前使っていた国内産のものと比較すると強度が弱く感じます。価格的に考えれば納得する範囲かな。
WesZ
Reviewed in the United States on September 11, 2018
These work just fine for me
Customer
Reviewed in the United States on March 6, 2018
Taller than most right-angle header. This stuff has the plastic strip below the bend (on the board facing side) rather than acting as a connector stop, which means that is taller than most right-angle header, and connectors or female header attached to it is not flush with the board
Richard
Reviewed in the United States on January 23, 2018
thanks
Brandon Rowsey
Reviewed in the United States on November 21, 2017
there header pins. idk what else to say about them lol
Customer
Reviewed in Canada on December 28, 2016
Excellent
しい
Reviewed in Japan on November 29, 2016
１ピンずつ分離できますが、届いた物は若干固く、２ピンで分離しようとすると、２ピン＋αで折れてしまいます。余計に折れてしまったものはムダになるわけではないので問題はありません。品質は申し分ありません。
Recommended Products