Your cart is empty.
Your cart is empty.The Spartan Locker, by USA Standard Gear, provides reliable traction at a low cost. The Spartan locker's design does not use the thrust washers and has a revolutionary spring and pin design that makes installation a snap!
van howard
Reviewed in the United States on June 17, 2024
I purchased the part because the specifications says it fits my 1962 CJ 5 Jeep with a 19 spline count. After talking to the tech support it does not fit my 1962 CJ 5. Very disappointed because their website says it does fit. Now I am in the process of finding one that does fit. I will probably have to send this one back for a refund.
Juan Carlos
Reviewed in Mexico on May 17, 2023
Cuidado corrobora compatibilidad
THE TREE MAN
Reviewed in the United States on June 1, 2022
They have a very pleasant to deal with and helpful staff and answer any questions via telephone in a timely manner.Great product & well made
Jeremy R.
Reviewed in the United States on May 20, 2022
Mahindra Roxor
Placeholder
Reviewed in the United States on May 19, 2021
Simplicity of how it works!
Kcc
Reviewed in the United States on February 8, 2020
Installed in a 2019 Mahindra Roxor. Put in rear axle. Make sure you install the original SPACER (see picture) around the cross pin. The instructions are not clear on this. Project took 6 hours the first time and I had to redo it to add back in the spacer. Took 1.5 hours the second time after I knew what I was doing. You will need a special axle hub puller removal tool and you will also need a slide hammer tool to remove the axle bearing. You do not need a 2” or 50mm socket as stated in the instructions. You will need a 36mm socket to remove the axle nut.
Richard Riggins
Reviewed in the United States on January 16, 2020
Work great just like advertized
Recommended Products
$220.89
$ 99 .00 $99.00
$535.00
$ 99 .00 $99.00