Your cart is empty.
Your cart is empty.Heater Hose Connector
Jose Mendoza
Reviewed in the United States on March 9, 2025
Lifesaver! It just work perfect on my BMW E91. Temporary fix while I receive the new hose. 5 minutes installation and ny car is on tracks again!
Theodore Singh
Reviewed in the United States on February 20, 2025
Perfect fit
Sifu
Reviewed in the United States on January 23, 2025
Just like the original
V.V.
Reviewed in Canada on January 21, 2025
Snapped the old hose connector and this replace it with no issue in the bmw e90. 2008
Kim
Reviewed in the United States on January 10, 2025
This part is a cost savor on my Audi A4 B8 since the OEM part comes as a hose assembly with clamped on connector and it's expensive. I was able to cut the clamp off and replace the corroded connector with this one without replacing entire heater hose. Time savor too and cheap.
Branavan Muralee
Reviewed in Canada on January 8, 2024
Bought this for my heater return line that connects to the bottom of my upper rad hose(that goes to oil housing amd radiator). Connected perfectly, no modifications required. Couldn't find this part anywhere else without the whole hose. This saved me a lot of trouble.Side note: make sure to use constant tension clamps on radiator hoses. Much safer than screw on clamps.
Containers work but don’t seal well.
Reviewed in the United States on January 14, 2024
Worked great for my wife’s 2011 Chevy Cruze 1.8L.
Jeff T
Reviewed in the United States on April 9, 2024
I have a 2019 Ram 1500 and for some reason the connector that was sending coolant to the radiator just snapped, as you could imagine it was smoke and fluid all over the engine compartment. Once I became aware of the problem, I searched for a replacement. Came upon this one, same as the original model. Great price, got it the next day. Works like a champ.
Marilu
Reviewed in Mexico on April 11, 2024
Aunque era un poco más larga quedo super bien
Alex Chi
Reviewed in the United States on September 20, 2023
The media could not be loaded.
Melissa
Reviewed in Canada on October 15, 2023
Anyone who has an s4 with the 4.2 this part won't be mentioned but it works for the heater core distribution hose on the back of the engine
Cliente
Reviewed in Italy on April 16, 2020
Tutto perfetto
C. Foley
Reviewed in the United States on January 9, 2018
Purchased for an Audi a4 B6 heater hose quick connector fit to the coolant flange. Perfect fit and resolved my severed coolant line. The o-ring needed to be pulled into place before installation. The hose connector side was 2mm thicker than the one that failed on me, (for the second time) so perhaps this one will last longer. To install I needed to remove the old factory metal ring which held the broken connector in place. To do this I used a dremel type clone, with a cut off disk and while the hose was still buried in the rear of the engine carefully positioned the cut off tool to cut through the ring. This worked pretty well, as there were lots of sparks, which abated when it was cutting the actual hose. To remove the ring, I used a small pick tool to losen and pull off the hose. I used this same pick tool to remove the broken connector from within the hose. I put a jubilee clip (hose clamp on the hose, and then inserted the connector. Before tightening I put the hose under the flange and moved things around so that it was properly aligned. Once tightened, I pulled the connector in place and engaged the locking clip.
Recommended Products
