Your cart is empty.
Your cart is empty.Our KLEARSTAND Fender Skirts are made with the highest quality, weather resistant, UV-Protected, ABS plastics in USA. It's versatile fit makes it compatible with many models. Pre-drilled holes for easy installation and/or replacement! **Please double check the measurements to ensure your trailer and our fenders are a match; we are not responsible for any misfits. Measurements are found in the photos as well as the key features found under the asking price!!**
George M
Reviewed in the United States on August 23, 2024
Installed on my 2011 Keystone Laredo 303TG, to replace the cracked and broken factory originals. Easy install, fit perfectly, look great, and appear to be more heavy duty than the originals. Recommend. Great value as well.
Leonard
Reviewed in the United States on August 16, 2024
These weren't a direct fit on my Cougar camper but they were the right length and work just fine. The holes don't line up but the old ones are covered. If you didn't know, you wouldn't know.
ginger rhea
Reviewed in the United States on June 10, 2024
Was replacing the set on my RV only to figure out these don’t cover near about with the original factory ones too come with zero hardware
Justin
Reviewed in the United States on May 28, 2024
So very nice good technology for my camper trailer yeah
Customer
Reviewed in the United States on June 7, 2023
I like these better than the original. They seem to be more sturdy and I like the flat look. The holes don't line up exactly so you will have to drill holes. I used Pop Rivets to install mine. I was sick and tired of the screws falling out.
Lucky Puppy
Reviewed in the United States on May 28, 2023
Reasonable price, quality seems good. Holes did not match perfectly but reused self tapping and was easy to install.I did add nylon washers to increase attach point size to greater than just the screw head, hope that will spread the pressure a little and extend the life before they all crack again…
Kinda Picky
Reviewed in the United States on June 8, 2022
The dimensions matched pretty closely, but the ends were tapered too much. The narrowness at each end caused the corners of the cutout to be exposed. I had to return and ended up making a set out of shiplap siding material for about $70. For the price of this vinyl set, you could almost buy a 4x8 sheet of bright tread aluminum.
David Hart
Reviewed in the United States on June 25, 2021
The quality is excellent. The price was approx 1/4 the cost of the original!!! I had to modify the fenders to fit . They look great
Recommended Products
$120.58
$ 52 .99 $52.99